User manual

page | 11
EDID Management
The DVI over 1 CAT6 w/ Galvanic Isolator can be switched between two EDID modes:
Internal or Pass-through. After changing DIP switch 1, the Sender unit must be
power-cycled for changes to take effect.
DIP Switch 1 Description
ON
(default)
Pass-through mode. DDC and HPD are
passed through. Both the connection status
and the full video capabilities of the monitor
are passed to the source device.
OFF Internal EDID mode. In this mode, a
generic EDID will be sent to the source
device. This setting is useful when
sufcient EDID data is unavailable from the
display device or EDID-related problems
are encountered.
Color Management
This feature is used to control the color depth for resolutions up to 1080i. By default, the
color depth is set to 8-bit. If the output resolution is 1080p or if DIP switch 1 is ON, then
this DIP switch setting has no effect.
DIP Switch 2 Description
OFF
(default)
Disables Deep Color support on the output
(display) device.
ON Enables Deep Color (12-bit) support on the
output (display) device.
DIP Switch Conguration
Basic Operation
1 2 3 4
ON
219
117
CTS
1 2 3 4
ON
219
117
CTS
1 2 3 4
ON
219
117
CTS
1 2 3 4
ON
219
117
CTS