User manual

page | 5
Page TitleIntroduction
Getting Started
ID Name Description
1 Link Connect a CAT-5e cable (or better) from this
port to the Link port on the Sender unit.
2 5V DC Connect the included 5V DC power supply to
this power receptacle.
3 Power This LED will glow bright blue once the
included 5V DC power supply has been
properly connected between the locking
power receptacle and an available
electrical outlet.
4 DVI Out Connect a DVI cable between the imaging
system (display) and the DVI Out port.
5 EQ Use this EQ pot to optimize the output
signal based on extension distance and
cable skew. See Adjusting the Signal
Quality (page 12) for more information.
6 Grounding Terminal Connect a grounding wire from this terminal
to an approved Earth ground. The grounding
wire should not be less than 16 AWG.