Operation Manual

 3
then attempts to synchronize with the DCF
radiosignalat4.00amand5am.
z The clockcanbe set to scan theradio signal
manually by holding “
” button(B5) for 3
seconds.Eachreceptiontakesaroundseveral
minutes. If receptions fail, scanning stops.
(“
” on LCD disappear) and repeats again
on next full hour. E.g. scanning failed at
8:20a.m.Itwillscanagainat9:00a.m.
z Stop scanning DCF radio signal by holding
“
”button(B5)for3seconds.
z “DST” shown on the LCD if it is in Daylight
SavingTimeMode
Note:
(1) All Setting mode will automatically exit in
around15secondswithoutanyadjustment
(2) For Time Zone: If you receive no RC‐DCF
frequency signal, the time zone should be
set to 0. Time
Zone is used in countries
whichcanreceivedtheDCFfrequencysignal
butthetime zone isdifferentfromGerman
Time(i.e.GMT+1).
5.Lockbuttons
z Hold“▼” (B2)and “▲”(B4)buttonatthe
same time for 5 seconds to lock the rest
buttons.Whenrestbuttons’functionsbeen
locked,icon “
” displayed.Hold “▼” (B2)
and “▲” (B4) button 5 seconds again to
unlock.
6.Precautions
z Theclocklosesitstimeinforma tionwhenthe
batteryisremoved.
z UseapintopresstheresetbuttoniftheUnit
doesnotworkproperly.
z Do not expose it to direct sunlight, heav y
heat,cold,highhumidityorwetareas
z Never clean the device using abrasive or
corrosive materials or products. Abrasive
cleaningagentsmayscratchplasticpartsand
corrodeelectroniccircuits
