Operation Manual

5
3. MAKING / RECEIVING CALLS
- Place the loop around your neck.
- Switch your hearing aid to T mode.
- Press the ON/OFF button. You are ready
to speak through your iLoop
TM
+.
- The Green LED will turn ON.
- During the call you can adjust the volume
of your device by using the volume control
knob located at the bottom of the iLoop
TM
+.
The iLoop
TM
+ will be automatically turned
OFF at the end of the call or after a few
minutes of silence. It will also turn ON
automatically when there is an Incoming
call or if the person at the other end speaks
after a long pause.
NOTE: Voltages presented to the
Telecomminications network are classified
TNV-3 according to EN60950 standard.
NOTE: When the batteries are discharged,
the Red LED will light up. Charge the
batteries immediately to avoid damage to
the unit or the batteries.
MAKING / RECEIVING CALLS