CONTENTS 2 DESCRIPTION P-Amp40 INSTALLATION 3-5 6-7 SETTINGS Volume control Tone control Boost switch Battery LED 8 8 8 8 8 TROUBLE SHOOTING 9 GUARANTEE 10
DESCRIPTION TOP Tone control Volume control Boost switch button Battery LED (*) Output socket connection (1) (*) Classified TNV-3 according to EN60950 standard.
DESCRIPTION BOTTOM Battery compartment Wall mount holes 12 Position rotary switch to match the connections in your handset 4
DESCRIPTION REAR (*) Output socket connection (2) (*) Classified TNV-3 according to EN60950 standard.
INSTALLATION 1 - HOW TO SET THE BATTERY The P-Amp40 amplifier needs with a 9V PP3 battery (not provided). To insert the battery into the amplifier: - Open the battery compartment located on the base by pressing the small plastic lock. - Insert the 9V battery with the correct polarity into the connector in the battery compartment. - Replace the battery cover. - The amplifier is now ready to be connected to the phone.
INSTALLATION 3. To test that the microphone is connected correctly, blow lightly into the mouthpiece. If you hear the ‘blowing sound’ in the earpiece, your P-Amp40 is now set. If you cannot hear the ‘blowing sound’, repeat 2 and 3 until both the earpiece and microphone are working correctly. Note 1: The rotary switch is factory set in the most of common wiring position so always try this first before turning the switch.
SETTING 3 - VOLUME CONTROL You can adjust the volume control level by using the “VOLUME” control slide switch located on the top. Volume can be adjusted from the standard level of your phone up to 30 dB or more. 4 - TONE CONTROL You can adjust the tone by using the 5 position “TONE” switch located on the top.
TROUBLESHOOTING IF THE AMPLIFIER DOES NOT WORK - Make sure all connections are plugged into the correct sockets (phone line cord, amplifier connections) and try other position on the rotary switch. - Make sure battery is correctly inserted and is fully charged. If you still have a problem when using your amplifier follow the instructions below: - Disconnect the amplifier from the telephone. - Connect the handset to the telephone.
GUARANTEE Sonic Alert warrants the device against any defect in materials or workmanship for the period of one year from the date of purchase. Should you experience a problem, contact our customer service department . Be sure to save your sales receipt as proof of purchase date should you need warranty service. Within a period of one year from purchase date, Sonic Alert will repair or replace (our discretion) your device at no cost, if a defect in materials or workmanship is found.
