Cordless Telephone User's Guide

Shaker Settings A switch located on the right side of the telephone handset allows the shaker to be activated when receiving an incoming call. Handset Registration The handset that came with your base is already registered to the base (factory setting). The
icon will be fixed on the display. If this icon is
flashing, the handset is not registered to the base and you will need to register it. (See Additional Handsets and Bases section).
17
Technical Settings Caller Display Settings There is a choice of two Caller Display settings: 1 for UK 2 for France Dialling Mode (Tone/Pulse) Settings In the UK, all telephone exchanges now use Tone dialling. The Tone/Pulse setting is pre-set to Tone on your telephone. If your phone does not dial out, it is probably being used from an older private switchboard (PBX). In this case, the Tone/Pulse setting must be changed to Pulse. Telephone Network Settings There is a choice of four telephone network settings. These settings are used to match the signal level when working on different telephone networks. A = Factory Setting – default value B = Normal C = Low D = Very Low Flash Time Settings Your telephone works with a flash time setting for United Kingdom (R=100ms). In France, flash time setting should be R=300ms. Dial Pause Settings This setting enables you to insert a 3 second pause after the first digit dialed. The rest of the telephone number is dialed normally. This can be used when plugged in at a private telephone exchange ( in a hotel, an office etc).
18
Shaker On Shaker Off
HANDSET SETTINGS
HANDSET SETTINGS