Operation Manual

This telephone has 3 quick dial memory buttons.

Once a number has been stored in a memory location, you only need to

press one button to make the call.

Create a Quick Dial Number

Lift the handset

Press

Enter the telephone number to be stored (maximum of 16 digits)

Press again

Select the quick dial location to store the telephone number (M1, M2

or M3) by pressing the corresponding button

Replace the handset

NOTE: Press if you need to insert a pause in the telephone number

Dial a Quick Dial Number

Lift the handset and wait for a dial tone

Press the quick dial location required (M1, M2 or M3)

The stored telephone number will now be dialed

Switching the Answering Machine On/Off

The answering machine can be switched on and off by using the

button. When switched to ON position, incoming calls will be answered by

the answering machine after a certain number of rings (see Answering

Machine Settings). When the answering machine answers an incoming

call, the caller will hear your outgoing message. After a short beep they

can then leave a message of up to 2 minutes. Should the caller exceed

this limit, the call will be disconnected. If the caller stops speaking for

longer than 7 seconds during the 2 minutes, the answering machine will

disconnect.

The memory will store approximately 14 minutes of incoming messages

(including the outgoing message).

NOTE: IF THE ANSWERING MACHINE IS OFF, NO CALLS WILL BE

ANSWERED AND 2 BARS WILL BE DISPLAYED

Also, if the Answering Machine is OFF, it will answer a call after 10 rings.

This is to allow some features to be accessed remotely.

Your CL210A answering machine can be operated from either:

• the telephone unit

• remotely from any external telephone.

Outgoing Message

Before you use the answering machine you should record an outgoing

message. The outgoing message is your message to an incoming caller

and may be up to 60 seconds in length.

You may want the message to tell the

caller that they may start speaking

once the beep is heard.

NOTE:

If no outgoing message has been recorded the display will flash

and no messages can be left.

QUICK DIAL

ANSWERING MACHINE