Operation Manual

Remote Control
Call the answering machine (using your telephone number)
While the outgoing message is playing, enter the remote code. If the
code is accepted you will hear two beeps
Select a remote control command (within 20 seconds) from the list
below
When you have finished accessing the machine replace the
handset.
Remote Control Commands
Command Functions
25
Play new messages
2#
Stop playback
During Playback
3#
Erase single message during playback
6#
Skip to previous message
7#
Skip to next message
8#
Repeat message
##
Stop playback
After Playback
3#
Erase all messages
7#
Record a new outgoing message, to stop
recording press
7# again
8#
Record a MEMO, to stop recording press
8# again
9#
Turn the answering machine either On or
Off. Three beeps indicate Off- Two beeps
indicate On
0# Room monitor, press 5# to stop the room
monitoring
When you remotely listen to messages for longer than 2 minutes and
30 seconds, you will hear a tone and you then need to press any key
on your telephone to continue the playback of the messages.
Recording a Memo
You can leave a memo for other answering machine users
Press and hold for 2 seconds
The message rE will be displayed
Start to record your memo after the beep
To end recording, simply release
The message can be played by pressing of the answering
machine or via the remote access function using a normal telephone.
Recording a Telephone Call
You can record a complete conversation i.e. what both you and the caller
say. If any other answering machine function is in progress, press
before beginning to record a call
Lift the handset to take the call
Press once during the call
The message 2r will be displayed. The answering machine then
records the telephone call
To end recording, press
Press to playback the recorded call.
Note: Do not forget to manually end recording otherwise,
the answering machine will continue to record until memory full
ANSWERING MACHINE
ANSWERING MACHINE
22