User Guide

5 6 7 8
PHONEBOOK
Your phone can store up to 50 private phonebooks in the cordless
handset with names and numbers. Each phonebook entry can have
a maximum of 20 digits for the phone number and 10 characters for
the name.
Phonebook entries are stored alphabetically by name.
To Add new entry
In idle mode :
Press MENU/OK
, and ▼/▲to select PHONEBOOK and press
MENU/OK
to access the phonebook list ( or empty).
Press MENU/OK
2 times to select ADD.
Press MENU/OK
to select NUMBER, enter number.
Press MENU/OK
to select NAME ,enter the name.
Press MENU/OK
to save.
SOS EMERGENCY CALL
SOS Settings
You need to set the SOS numbers before you can make SOS
emergency calls.
Using the handset :
Press LEFT SOFTKEY
and ▲/▼ to select SET SOS.
Press LEFT SOFTKEY
and ▲/▼ to select SOS NUMBER.
Press LEFT SOFTKEY
and ▲/▼ to select the SOS number
to edit (SOS 1, SOS 2, SOS 3 or SOS 4).
Press LEFT SOFTKEY
and select ADD to enter a new number
or EDIT to modify the number stored already.
Press LEFT SOFTKEY
and enter a new name or edit the name
stored already.
Press LEFT SOFTKEY
to confirm or RIGHT SOFTKEY
to delete.
Make SOS Emergency Calls
Press and hold 3 seconds SOS key on the handset to enter the
emergency calling sequence from the SOS 1 number to SOS 4
number. A call will be first dialed to the SOS 1 number. If the SOS 1
number does not answer in 60 seconds, the call be will made to the
SOS 2 number, and so on.
Note: The other party receiving the SOS message must press any
number on their phone to open the SOS call. Thereafter by pressing
any number on their phone every two minutes will keep the emergency
call open else the phone stops the call 10 seconds after.
Record SOS Messages
You can record your customized SOS message to be played when
you dial out an SOS emergency call otherwise the default message
will be played.
Press LEFT SOFTKEY and ▼/▲to select SET SOS.
Press LEFT SOFTKEY
and ▲/▼to select SOS MSG.
Press LEFT SOFTKEY
and ▼/▲ to select RECORD.
Press LEFT SOFTKEY to start SOS message recording and
“RECORDING” will be displayed.
Press LEFT SOFTKEY
to save your SOS message.
Play SOS Messages
Press LEFT SOFTKEY and ▲/▼ to select SET SOS.
Press LEFT SOFTKEY and ▲/▼ to select SOS MSG.
Press LEFT SOFTKEY to show PLAY.
Press LEFT SOFTKEY to start SOS message playback.
Press 5 key to stop SOS message playback.
SET SPEED DIAL KEYS IN HANDSET
Press LEFT SOFTKEY and ▲/▼ to select PHONEBOOK.
Press LEFT SOFTKEY
and ▲/▼ to select SPEED DIAL.
Press LEFT SOFTKEY, use. ▲/▼ to select the speed dial key.
Press LEFT SOFTKEY
, select ADD or EDIT.
Press LEFT SOFTKEY
and enter the phone number.
Press LEFT SOFTKEY to enter the NAME.
Press LEFT SOFTKEY .to confirm.
To use one speed dial key, press and hold in idle mode the key
between 1 to 9 for 3 seconds (you hear a beep of confirmation).
PICTURE BIG BUTTON MEMORIES
On the base
You have the choice to store 10 picture memories.
In idle mode: Press
, enter the phone number with the key
M0 to M9 of the base, Press and press the picture memory
button that you have chosen.
Using the handset:
1) Press MENU/OK , select ▼▲PHOTO MEM,
2) Press MENU/OK , select ▼▲M1 to M0,
3) Press MENU/OK , select ADD or EDIT.
4) Press MENU/OK , enter number
5) Press MENU/OK , enter name then OK to save
You have the option to enter a voice name in choose VOICE TAG
and RECORD at the point 3.
If you receive a call with the number registered with a voice tag, you
can hear the voice name on the base and on the handset.
NOTE: To use a picture big button memory in idle mode, press and
hold the picture until the LED turns on, on the base.
If you want to pass the number from the base to the handset, lift the
handset off the base to take the call.
If the handset is not placed on the base, press
to take the line
and press
on the base to stop the call.
ANSWERING MACHINE
Your telephone base includes a telephone answering machine that
records unanswered calls when it is on. The answering machine can
store up to 59 messages within the maximum recording time of
approximately 30 minutes. As well as recording incoming messages,
you can record memos for other users of your phone.
Switching Answering Machine On/Off
Using the handset:
1. Press LEFT SOFTKEY and ▼/▲ to select ANS.SYS.
2. Press LEFT SOFTKEY
and ▼/▲ to select TAM ON / OFF.
3. Press LEFT SOFTKEY
and ▼/▲ to select ON or OFF.
4. Press LEFT SOFTKEY
to confirm.
Play Messages on TAM
If you have new messages, the display will show e.g.2 NEW
MESSAGE, which means you have 2 new messages. The new
messages are played first, and then are saved as old messages, until
they are deleted. Old messages are played again after all new
messages are played completely.
Using the handset:
1) Press LEFT SOFTKEY
and ▼/▲ to select ANS. SYS.
2) Press LEFT SOFTKEY
to show PLAYBACK.
3) Press LEFT SOFTKEY
again to start message playback and
the screen displays the date and hour of the message received.
4) During message playback, press ▼/▲ to adjust the message
playback volume respectively.
NOTE: After new message is played, the new message will be
saved as an old message automatically unless it is deleted.
5) Press LEFT SOFTKEY
and ▼/▲ to select STOP,
FORWARD, PREVIOUS or DELETE to perform the following
functions during message playback.
• STOP: Stop the current message playback and return to the ANS.
MACHINE menu.
• FORWARD: Skip to play the next message. The date and hour
information of the next message will display if there is next message.
• PREVIOUS: Skip to repeat playing the current message from the
beginning. The date and hour information of the current message
will display.
• DELETE: Delete the current message and the next message will
be played.
6) Press LEFT SOFTKEY
to confirm the setting.
Set the Answer Delay
You can set the number of rings before the answering machine
answers and starts playing your OGM. You can set the answering
machine to answer after two to eight rings or TIME SAVER.
The TIME SAVER function answers calls after 6 ring signals, until the
first new message has been registered - then the answering machine
switches to answering after approximately 2 signals. This is useful
when using remote access; if you call up the answering machine and
there is no reply after four rings it means there are no messages
recorded and you can hang up before you are charged for the call.
Using the handset:
1) Press LEFT SOFTKEY
and ▼/▲ to select ANS. SYS.
2) Press LEFT SOFTKEY
and ▼/▲ to select SET TAM.
3) Press LEFT SOFTKEY
and ▼/▲ to select ANSWER DELAY
(Available options: 2 RINGS, 4 RINGS, 6 RINGS, 8 RINGS, 10
RINGS or TOLL SAVE).
4) Press LEFT SOFTKEY
to confirm.
REMOTE OPERATIONS
If you are away from your home, you can call your answering machine
to switch on or off the answering machine and listen to your messages
remotely using another tone-dialing phone.
1) Place a call from a tone-dialing phone.
2) When the answering machine answers the call and starts playing
OGM, press
.
3) Enter the 4-digit Remote Access PIN (default PIN is 0000).
4) Press the following keys to carry out your desired function.
key
Functions
While message is not
playing
While message is playing
2
Delete the current message playback
4
Repeat playing the current message
from the beginning. Press twice to skip
backward to the previous message.
5
Stop the current message playback
6
Skip forward to play the next message
7
Turn on the answering
machine
9
Turn off the answering
machine
*
Enter the 4-digit remote
access PIN
NOTE: When your answering machine memory is full , the answer
mode will change to ANSWER ONLY automatically.
It will change to ANS & RECORD mode automatically after some
messages have been deleted.
You cannot delete new messages until they have been listened to.
ALARM function
You have the choice to enter 10 Alarms.
1) Press LEFT SOFTKEY
and ▼/▲ to select REMINDER.
2) Press LEFT SOFTKEY
and ▼/▲ to select your alarm.
3) Press LEFT SOFTKEY and ON/OFF to select ON.
4) Press LEFT SOFTKEY and enter the time.
5) Press LEFT SOFTKEY
and choose the frequency.
6) Press LEFT SOFTKEY to save.
TALKING function
You have the can choose to activate or deactivate the function
Talking Digits.
Activate: this function announces the digit dial.
1) Press LEFT SOFTKEY
and ▼/▲ to select TLK DIGITS.
2) Press LEFT SOFTKEY
and ▼/▲ to select ON or OFF.
3) Press LEFT SOFTKEY
to save.
TECHNICAL SPECIFICATIONS
Basic Information
Valid Range
Indoor : 50m / Outdoor:300m
Handset
Operating time
Standby time : 100 hours
Talk time : 10 hours approx.
RF Parameter
Frequency
1.88 GHz to 1.9GHz
Nb Channels
10
RF power
< 250mW
Power Supply
Base
Input 100-240V 50/60Hz;
Output DC6V 0.6A, 3.6W adapter
Charger
Input 100-240V 50/60Hz;
Output DC6V 0.45A, 2.7W adapter
Handset
3 batteries AAA 1.2V/600mAh rechargeable
MAINTENANCE
Clean the surface of the housing with a soft, fluff-free cloth. Do not
use any cleaning agents or solvents.
GUARANTEE
From the moment your Geemarc AMPLIDECT595 Photo is purchased,
Geemarc guarantee is for the period of two years. During this time,
all repairs or replacements (at our discretion) are free of charge.
Should you experience a problem then contact our help line or visit
our website at www.geemarc.com.
The guarantee does not cover accidents, negligence or breakages
to any parts. The product must not be tampered with or taken apart
by anyone who is not an authorized Geemarc representative.
The Geemarc guarantee in no way limits your legal rights.
IMPORTANT: YOUR RECEIPT IS PART OF YOUR GUARANTEE
AND MUST BE RETAINED AND PRODUCED IN THE EVENT OF
A WARRANTY CLAIM.
Please note: The guarantee applies to the United Kingdom only.
DECLARATIONS:
CE Directives
Geemarc Telecom SA hereby declares that AMPLIDECT595 Photo
is in compliance with the essential requirements and other relevant
provisions of the Radio Equipment Directive 2014/53/UE.
The CE declaration of conformity may be consulted at
www.geemarc.com
Electrical connection: The apparatus is designed to operate from
a 230V 50Hz supply only. (Classified as hazardous voltage according
to EN62368-1 standard). The apparatus does not incorporate an
integral power on/off switch. To switch off the apparatus, disconnect
the power adaptor.
When installing the apparatus, ensure that the mains power socket
is readily accessible.
Telephone connection:Voltages present on the telecommunication
network are classified TNV-3 (Telecommunication Network Voltage)
according to the EN62368-1 standard.
Recycling Directives
The WEEE (Waste Electrical and Electronic Equipment) has been
put in place for the products at the end of their useful life are recycled
in the best way.
When this product is finished with, please do not put it in your domestic
waste bin. Please use one of the following disposal options:
- Remove the batteries and deposit them in an appropriate WEEE
skip.
Deposit the product in an appropriate WEEE skip.
- Or, hand the old product to the retailer. If you purchase a new one,
they should accept it.
Thus if you respect these instructions you ensure human health and
environmental protection.
For product support and help visit our website at www.geemarc.com
E-mail : [e-mail] telephone [phone]
lines are open 09h00 to 16h00 Mon to Fri
2 Rue Galilée, Parc de l’Etoile, 59791 Grande-Synthe, France
This product is made in China To Geemarc Telecom
QUGAMPLIDECT595-Photo_En_A3_V1.5