Operation Manual

Way 2: Using the base unit
When you have one or several new messages,
press the key to play it/them. Use the or
ey to play the desired one. Press the key
once to re-play the current message or press it
twice to play the previous one. If there is no new
messages, press the key to play the saved
messages. Press the key again to finish.
K
12
49
Installing Batteries (continued)
Charging Handset
3.
To re p la c e th e b a tt e ry
cover, slide the cover up
until it snaps in place.
The batteries need to be replaced
if they do not recover their full
storage capacity after recharging.
When replacin g t h e batteries,
always use good quality Ni-MH
A A A r e - c h a r g e a b l e b a t t e r i e s .
Never use other types of battery.
Notes:
! Important Note: Before initial operation, YOU SHOULD FULLY
CHARGE THE HANDSET for about 15 hours.
To charge the handset, place it on the base.
Result: When you place the handset on the base, the handset
automatically turns on.
Message (AMPLIDECT285™ only)
The feature allows you to leave a message to the
owner who is not at home. When a call is received
in answer-record mode, the machine will play
Announce1, and then performs message
recording. The process is as follows:
After N times ringing, the phone enters answer-
record mode automatically and starts to play
Announce1. The caller can start to record after a
tone.
Play New/Saved Messages
4. The phone will announce "You have N new
message(s)" or "You have N saved
message(s)". The relevant messages will be
played one by one. You can use the key
to delete the current message or the Back soft
key to stop the playing and exit.
Way 1: Using the menu
1. Press the TAM soft key in Standby mode.
2. Press the Down key to choose Message, use
the Select key to confirm.
3. Press the Select key again to choose New
MSG or press the Down key to choose Saved
MSG, press the Select key to confirm.
Note:
During the playing, you can use the or
key to adjust the volume.