Operation Manual

6
Phone Layout and Keys Function (continued)
Base : AMPLIDECT285™
Rear View
Power Jack
Phone Line Jack
Charge pins
Base display
Microphone
Speaker
Remote Control (AMPLIDECT285™ only)
You can access many features of your answering
machine remotely from any touch tone telephone.
A four-digit security code (remote code) is
required to access the system and the factory
default one is 0000. To enter remote access:
1. Dial your telephone number from any touch
tone telephone.
2. When the Announce1/Announce2 starts to
play, you may enter the remote access mode
by inputting the remote code.
3. After you enter the remote code, the system
will play the menu of commands. You can then
follow the commands to operate.
Note:
If you enter the remote code incorrectly the
answering machine will ask you to enter the
code again. You are then given two more
attempts to enter the correct remote code
before the line is disconnected.
Remote access commands
Button
Function
Play the main menu
Play the new messages
Play the saved messages
Delete all the messages
Switch the answering machine on/off
Record Announce1/2 (Depends on your
setting)
Note:
You had better stop playing message before
hanging up.
When you press or key to play back the
messages, press to replay current message,
press to stop, press to delete current
message.
After you record the Announce1/Announce2, press
the key or the key to finish. The system
will play the announcement you have recorded.
Announce 1/2
Play/Stop
Previous Message/
Next message
Erase message
Tam On/Off
Speakerphone
setting
Base : AMPLIDECT280™
Paging
Charge pins
Paging
55
53