User's Manual

Nikon master control Multi mode
Setting for groups
① Press【MODE】button to select transmitter mode
as pic showed . Under this mode, the settings of
all groups are the same.
② Under non-grouping setting status, press【←】/
【→】button to set flash power, flash output is
adjustable from 1/4 to 1/128, total 6 levels.
④ Under Frequency setting, press【OK】button to
exit, after screen flash flickered a few times, press
【←】/【→】 button to adjust numbers of time,
flash times are available from 1-40.
③ Under standby status, press 【OK】button, you can
see the Frequency numbers are flickering, press
【←】/【→】button to adjust frequency, available
frequency from 1HZ-100HZ.
1-8
1/16
1-12
1/32
1-20
1/64
1-40
1/128
Group A Flash power & Flash frequency connection table
Flash power
Flash frequency
1-4
1/8
1-2
1/4
Nikon master control Multi mode
⑤ After finished flash parameters, Press【A】/【B】/
【C】/【D】button for a few seconds to select or exit
flash grouping setting, the arrow refers to the group
you’re setting.
17 18
Automatic focusing assis
Master Control Multi mode
Wireless Channels
Group A Switch
Group B Switch
Group C Switch
Group D Flash settings
Focal distance
Aperture
Flash output power
Flash frequency
Flash times