User's Manual

Power on
Load batteries correctly, push the switch to 【ON】to
turn on the trigger, then LCD screen & 2 color lights
are on simultaneously, system check and complete
initialization, enter standby mode, red indicator flashing.
09 10
Install the trigger on the hot shoe contact
from top of camera.
1. Unlock the twist lock by sliding to the left.
2. Insert holder completely into camera hot shoe,
and push it all the way in contacts.
3. Slide the twist lock to the right to lock it, and make
sure it sits securely on the hot shoe.
Preparation before use Functions description
Test
Press【TEST】, trigger send group modes and settings
info to flash lights which in the same channel and flash
once to test the transmission.
LCD
Press any button to light LCD, after 10 seconds no operate,
LCD light turns off.
Restore Factory settings
Press [ok] for 3 seconds, the trigger will restore to factory
settings.
Mode options
Turn on the trigger, press 【Mode】, now trigger enter
into mode options, after turning on the transmitter, you
can cycle through Canon Mix mode, Canon Master Mix
mode and Canon Master Multi mode.