Warranty

Push the switch to , the heater starts working and the indicator light is red.
Model: DH-QN06
Item No.: HF01
Instruction Manual
2
103mm
43mm
7.5mm
18.5mm
Important Instructions
5
Operating Instruction
6
7
Cleaning and Maintenance
4
Troubleshooting
Warranty
2 3
4
Toll Free:1-844-801-8880
[e-mail]
6
Table of contents
IMPORTANT INSTRUCTIONS
IMPORTANT INSTRUCTIONS
OPERATING INSTRUCTION
5
CLEANING AND MAINTENANCE TROUBLESHOOTING
Warranty
7
Electric Heater
Specification
Specification
Product Name Electric heater
Item No.
HF01
Model
DH-QN06
Max Watts
500
Unit Voltage
120V,60Hz
Unit dims
7.68*5.12*2.95 inch
Problem
Heater will not
power on and shuts
off unexpectedly
The heater is
creating a burning
smell
Probable Cause
Heater is not plugged into
a 120V polarized
outlet/receptacle.
The heater was
overheat protection
feature has turned it off
Ensure unit is in OFF
position. Plug in unit
and attempt to turn on
again.
Turn off the heater,un-
plug it and wait at least
10 to 20 minutes for the
unit to cool down. Plug
the heater back
in and turn it on again.
Ensure room in which
heater is situated is
well ventilated.
Remove the combusti-
ble materials preventing
air intake into the
heater.
A drop of oil fell on the
heating coil during the
manufacturing process.It
will quickly evaporate
and should not occur
again.
Check & ensure there
are no combustible
materials within 3’
(0.9 m) of the heater
Solution
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF, DOING SO COULD VOID
THE WARRANTY AND CAUSE DAMAGE OR PERSONAL INJURY.
If your heater fails to operate, please follow these procedures prior to contacting Customer
Service.
TROUBLESHOOTING
封底
148mm
210mm
Kool Solutions For Life
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS CONTROL PANEL
OPERATING INSTRUCTION
1. Read all instructions before using this heater.
2.
This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. Use handle when moving the unit. Keep flammable materials such as
furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m)
from the front and top of the heater and keep them away from the sides and rear
of the heater. Keep the rear grille away from walls or drapes so as not to block
the air intake.
When switching on the appliance for the first time, allow it to run at full power
for about two hours to get rid of the unpleasant smell. Make sure that the
room in which the appliance is located is well ventilated during this operation.
It is normal for the appliance to emit small cracking sounds when you turn it
on for the first time.
3.
Extreme caution and supervision is necessary when any heater is used near
children or invalids and whenever the heater is left operating and unattended.
4.
Always unplug heater when not in use.
5.
Do not use any heater with a damaged cord or plug or after the heater malfunc-
tions or has been dropped or damaged in any manner. Discard heater or return
to an authorized service facility for examination and/or repair.
6.
Do not use outdoors.
7.
This heater is not intended for use in bathrooms, laundry areas or other similar
indoor locations. Never locate heater where it may fall into a bathtub or other
water container.
8.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Do not route cord under furniture or appliances. Arrange
cord away from traffic areas and place it where it will not be tripped over.
9.
10.
To disconnect heater, turn controls to off, then remove plug from outlet.
This appliance has a polarized plug (one blade is wider than the other). This
plug is intended to fit a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, consult a qualified
electrician. Do not connect the heater to extension cords, surge protectors,
timers, direct breakers, or an outlet with other appliances connected to the
same outlet. Risk of fire, overheat, malfunction, property damage, injury, or
even death may result if not adhered to!
11.
Connect to properly polarized outlets only.
12.
Do not insert or allow foreign objects to enter ventilation or exhaust openings,
as this may cause an electric shock or fire, or damage the heater.
13.
To prevent a possible fire, do not block air intakes or exhaust in any manner. Do
not use on soft surfaces, like a bed, where openings may become blocked.
PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS HEATER.
WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND
PERSONAL INJURY, INCLUDING THE FOLLOWING:
14.
A heater has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
15.
Use this heater only as described in this manual. Any other use not recom-
mended by the manufacturer may cause fire, electric shock, injury to persons
or other damage to property.
16.
This heater must be plugged into a 120V, 10amp (or more) circuit of its own.
Nothing else can be plugged into the same circuit. If unsure if you home meets
this specification, consult a certified electrician prior to use. Risk of fire,
overheat, malfunction, property damage, injury, or even death may result if
not adhered to!
17.
To prevent overload and blown fuses, be sure that no other appliance is
plugged into the same outlet or into another outlet wired into the same circuit.
18.
It is normal for the heater’s plug and cord to feel warm to the touch. A plug or
cord that becomes hot to the touch or becomes distorted in shape may be a
result of a worn electrical outlet. Worn outlets or receptacles should be
replaced prior to further use of the heater. Plugging heater into a worn
outlet/receptacle may result in overheating of the power cord or fire.
19.
Ensure the heater is on a stable, secure surface to eliminate the potential of
tipping over.
20.
Always plug heaters directly into a wall outlet/receptacle. Never use with an
extension cord or relocatable power tap (outlet /power strip).
21.
Be sure that the plug is fully inserted into appropriate receptacle. Please
remember that receptacles also deteriorate due to aging and continuous use:
check periodically for signs of overheating or deformations evidenced by the
plug. Do not use the receptacle and CALL your electrician.
22.
Check that neither the appliance nor the power cable has been damaged in any
way during transportation.
23.
Make sure that no pieces of polystyrene or other packaging material have been
left between elements of the appliance. It may be necessary to pass over the
appliance with a vacuum cleaner.
24.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
Be sure to plug into a 120V AC,60Hz outlet. Check that the plug and the socket fit well,
then you can operate the appliance.
1. Plug into a 120V AC outlet.
2.
3. Push the switch to , the heater will starts working and swinging automati-
cally, the indicator light is red.
4. Push the switch to , the heater stops working, the indicator light is off.
CAUTION: To prevent electric shock, match wide blade of plug to wide slot,
fully insert.
SAVE THESE INSTRUCTIONS
LIMITED WARRANTY
HOME EASY LTD warrants to the original consumer or purchaser this Electric Heat-
er(“Product”) is free from defects in material or workmanship for a period of one (1)
year from the date of purchase. If any such defect is discovered within the warranty
period, HOME EASY LTD, at its discretion, will repair or replace the Product at no cost.
This limited warranty is good only to the original purchaser of the product and effec-
tive only when used in United States.
For warranty or repair service: Call 844-801-8880 and choose the appropriate prompt,
or email [e-mail]. Please have your Product’s model number, your name,
address, city, state, zip code and phone number ready.
NO OTHER WARRANTY IS APPLICABLE TO THIS PRODUCT.THIS WARRANTY IS IN LIEU
OF ANY OTHER WARRANTY, EXPERSS OR IMPLIED. INCLUDING WITHOUT LIMITATION,
ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO
THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW. IT IS LIMITED IN DURATION
TO THE EXPRESS WARRANTY PERIOD ABOVE. NEITHER THE MANUFACTURER NOR ITS
U.S.DISTRIBUTOR SHALL BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL,
INDIRECT.SPECIAL, OR PUNITIVE DAMAGES OF ANY NATURE. INCLUDING WITHOUT
LIMITATION. LOST REVENUES OR PROFITS, OR ANY OTHER DAMAGE WHETHER BASED
IN CONTRACT, TORT, OR OTHERWISE, SOME STATES AND/OR TERRITORIES DO NOT
ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAG-
ES OR LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS. SO THE ABOVE
EXCLUSION OR LIMITATION MAY NOT APPLY TO YOU .THIS WARRANTY GIVES YOU, THE
ORIGINAN PURCHASER, SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER
RIGHTS THAT VARY FROM STATE TO STATE OR TERRITORY TO TERRITORY.
PROTECTION SYSTEMS
CLEANING AND MAINTENANCE
This heater includes an overheat protection system that shuts the unit off when
parts of the heater overheat. If this occurs, turn the heater off, unplug it, and
inspect and remove any objects on or adjacent to the heater that may cause high
temperatures. Wait 10 to 20 minutes for the unit to cool down then plug it back in
and resume the normal operation.
OVERHEAT PROTECTION
1. Before any cleaning, make sure that:
2.Regular cleaning:
a. The heater is turned OFF
a. Interior dust can often be removed by using a vacuum cleaner with a crevice tool
attachment.
b. Do not use cleaning spray-on liquids or other chemicals on the unit.
c. To clean enclosure, use a clean, soft and lightly damp cloth to gently wipe off the
dirt from the surface of the unit. Be sure not to wet the heating element and the
switches. Allow the unit to dry completely before using it.
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE HEATER
AS THIS COULD CREATE A FIRE OR ELECTRIC SHOCK HAZARD.
b. Disconnect power supply at source by removing plug from power outlet.
1. Perform the cleaning procedures described in “CLEANING AND MAINTENANCE”
section.
2.Wipe all parts to dry.
3.Pack the heater in a plastic bag and store it in a cool, dry place.
STORAGE