Installation Guide

7
INSTALL THE HOOD
Note: At least two people will be required to mount the hood.
1. Raise the hood into its mounting position.
2. A
lign the rectangular opening on the back of the hood
with the wall-mounting bracket. Gently lower the hoo
d
unt
il it securely engages the bracket.
3. O
pen the Al. filter and find the two φ8 mm holes
on
t
he back of the hood. Level the hood with 2 mounti
ng
scr
ews (ST4*30mm) with washer. Use drywal
l
anchors provided.
4. M
easure the height of the glass to the slider duct fixing
support. Adjust the height of the chimney according t
o
the height. Then use the duct fixing support with two
screws (4x8mm) to fix the chimneys. Shown as in the
picture.
5. P
ut the chimney on the hood, use two screws (4x8mm)
to fix the chimney to the slider duct fixing support.
6. Use the other two screws (4x8mm) to fix the bottom of chimney.
7. A
fter adjusting the position, open the filter
and
f
ix the body inside with safety screws.
4x8mm
Screw
Screw
4x8mm
Safely Screw
Safely Screw