User Manual

Section 3 Low Power Protection Warning

If the volume setting is too high, the power requirement may be greater than

the power provided by computer or external 5V DC Charger. At this time, the

Low Power Protection Warning will appear. Please reduce the volume immedi-

ately. Connect the two USB connectors of Micro USB Touch and Power Cable to

the two USB ports on computer. If the vol-

ume is not reduced in time, the Monitor will

decrease the volume and brightness auto-

matically.

Fig.: Low voltage warning shown at upper

right corner on screen.

Chapter 5 Specification

Section 1 Plug and Play

The On-Lap Monitor conforms to VESA DDC standard and supports VESA

DDC2. DDC2B is a bi-directional data channel based on I

C protocol. The host

can request EDID information over the DDC2B channel. The On-Lap Monitor is

able to inform the host system of its identity, and depending on the level of

DDC used, communicate additional information about its display capabilities.

Section 2 Pin Assignment

1. HDMI Connector Pinout

Fig.: HDMI-A Connector

(Connect to HDMI port)

6. Audio: Adjust volume or select mute

7. OSD Menu

OSD Timer: Adjust OSD Time

OSD H. POS: Moves OSD left and right

OSD V. POS: Moves OSD up and down

OSD Transparency: Makes OSD transparent

Language: Select OSD language

Reset: Restore to factory setting

8. Input Source: Select VGA signal source, HDMI signal, DisplayPort signal

or Auto Detect

9. Information: Display factory version