User Manual

Section 4 Windows 8.1/ 10 Touch Gesture Description
Common Touch Gesture Introduction:
1. Use finger to swipe in from edge:
1
Swipe in from the right edge of
the screen (Arrow 1) : Open the five
charms Search, Share, Start, De-
vices, and Settings
2
Swipe in from the left edge of
the screen (Arrow 2) : Switch be-
tween apps
3
Swipe in from the left edge of
the screen then out toward the left
edge of the screen (Arrow 3): Display all apps
4
5
Swipe in from the top edge (Arrow 4) or bottom edge (Arrow 5):
Display commands of app, like Add New, Reminder, etc.
6
With touch, drag the app from the top edge of screen (Arrow 6) to the
bottom of the screen: Close app
2. Select item: Tap on the item to open. This function is similar to clicking on
mouse.
3. Press and hold the item for a few seconds then release: Display item
information. This function is similar to right-clicking on mouse.
4. Zoom in and out: Touch the item with two fingers then move fingers
toward each other (pinch) or away from each other (stretch).
5. Slide finger on the screen, horizontally or vertically, to move through
content. This function is similar to scrolling with a mouse.
Chapter 4 Hot Keys and OSD Instructions
Section 1 Hot Keys and LED Light Description
*Notice: If need to adjust “Increase/up” or “Decrease/down” continuously , press
the button and hold. Do not press two buttons at the same time, due it may cause no
response or fault response.
LED Lights Description
It shows green light when turn on On-Lap Monitor and shows red light when
stand by.
10
Notice of operation system compliance
On-Lap 1303I supports Windows10/8.1/7 . You can plug & touch on Win-
dows 10/8.1/7 without any driver installation
For Windows 8/8.1 before 2015/10/15, which contains different touch oder,
may not recognize 1303I. Please upgrade your Windows, or email Gechic for
1303I firmware change.
For Linux and Android developer, please active”HID multitouch panels”
while establishing kernel, and the external touch monitor can be supported.
Or email Gechic for Linux driver for setting in Linux/Android system.