User Manual

Chapter 2 Installaon Instrucons
Secon 1 Installaon of Horizontal Display
Refer to the Fig., ① take
the magnec buckle o
rstly, ②fold and aach
the rubber side of the
magnec buckle on the
mental plate. Adjust the
posion of the magnet
buckle to change the view-
ing angles.
The min. viewing angle of horizontal
display is 40 degrees. Do not aach the
magnec buckle higher than the blue line ,
otherwise it may cause the monitor over-
turning.
3
Rear Dock
The Rear Dock shall be installed on the backside connector of
1102/1503. It equips with HDMI-A input and USB-A input for
installing Computer Sck or HDMI wireless display. For aach-
ing a power bank on the Rear Dock, refer to Chapter 2>Secon
8.
1102 Mul
Mount Kit
Proprietary for On-Lap1102 . Can be used as a stand of touch
monitor for varies viewing angles; can be installed on wall
mount or arm of VESA 75. Please refer to Chapter 2.
1102 Tripod
Mount Kit
(1/4”screw hole)
Proprietary for On-Lap1102. A 1/4” screw hole allows you to
install On-Lap1102 on a camera tripod. Please refer to Chapter
2.
Stand 4
An oponal stand for On Lap 1102. It supports horizontal
display and 4 adjustable viewing angles.
As the g. below, rotate aside the Cover Locks rstly, and take the monitor out.
Then turn the monitor's backside to the Protecve Cover:○
1
Put the boom half
of the monitor into the Protecve Cover, and○
2
Put the top half of the monitor
into the Protecve Cover. Rotate down the Cover Locks to prevent the monitor
from sliding out.