User Manual

P.S. If the monitor does not get enough power from a single USB port, it
may cause splash screen or display interrupon. Please connect to two
USB ports on your PC or the 5V-2A adapter.
4
As the g. , connect On-
Lap 1102 to a laptop. On-
Lap 1102 can be powered
on through two USB ports
or a 5V-2A adapter. The
video input source is
"HDMI1".
Secon 2 Installaon of Vercal Display (Only for On-Lap 1102H)
As the g. below, rotate aside the Cover Lock rstly, and take out the moni-
tor, then turn the monitor's back side to the Protecve Cover . Do keep the
buons on the topside. ○
1
Put the boom half of the monitor into the Protec-
ve Cover, ○
2
Put the top half of the monitor into the Indentaon of the Pro-
tecve Cover. Rotate down the Clover Lock.
The min. viewing angle of vercal display
is 60 degrees. Do not aach the magnec
buckle higher than the orange line, or it may
cause the monitor overturning.
As the g. on next page, connect On-Lap 1102 to a laptop. On-Lap 1102 can
be powered on through two USB ports on your PC or a 5V2A adapter.