Guide

105 Webster St. Hanover Massachusetts 02339 Tel. [phone] Fax [phone] www.gearseds.com
Copyright GEARS Educational Systems 2007
20
Strip 3/4” of insulation from each of the black and red leads on both speed controllers. Twist the two red
leads together and crimp a ¼” insulated spade connector onto the end of the black leads. Repeat this step
for the red leads. The finished assembly is shown above. Remember: Black to black and red to red!
Failure to observe this instruction will damage the speed controllers and void the warranty. For best
results, always refer to the documentation that comes with the specific speed controller you are using.
Fasten the single pole, single throw toggle switch to the front of the SMP as shown in the photo above.