Manual

3
105 Webster St. Hanover Massachusetts 02339 Tel. [phone] Fax [phone] www.gearseds.com
Copyright GEARS Educational Systems 2005
Note: Be certain to align the orientation of the 13 hole
angles as shown in figures 3 and 4. Mount the 13 hole
angles outboard of the fish plates as illustrated.
Note: It will be necessary to position the washer and nut in
place BEFORE passing the machine screw through the 13
hole angle.
Step Three: Attach the Cross Bracing
Obtain these components:
Qty. Description
1 11 hole flat bar
1 7 hole flat bar
3 #10-24 x 3/8” PH machine screws,
nuts and washer assemblies.
2 #10-24 coupling nut
2 #10-24 x 3/8” machine screw and washer
Procedure
Use two #10-24 x 3/8” Phillip head machine screws to
attach the 11 hole flat bar across the 13 hole angles.
Use one #10-24 x 1/2” Phillip head machine screws to
attach the 7 hole flat bar diagonally across the 11 hole flat
bar. Use one #10-24 x 3/8” machine screw and flat washer
with a #10-24 coupling nut to attach the 7 hole flat bar to
the right side 13 hole angle as shown in figure 5.
Fasten an additional #10-24 x 3/8” machine screw and flat
washer with a #10-24 coupling nut to the left side 13 hole
angle as shown in
Fi
g
. 4 Fi
g
. 5
Fi
g
. 6
Fi
g
. 4