Owner manual

11
09704-09.2013-DGbFITrCn
D
GB
F
I
TR
CN
4| Compressor assembly
4.1 Setting up
4.2 Maximum permissible inclination
A
max.30°,
max.2minutes
a
max.15°,
continuous
operation
ATTENTION! Poor lubrication can damage the compressor. Respect the stated
values.
INFO! Newcompressorsarefactory-lledwithinertgas(3barnitrogen).
Leave this service charge in the compressor for as long as possible
and prevent the ingress of air.
Check the compressor for transport damage before
starting any work.
Fig.8
 Transportandsuspensionunitonbotheyebolts(Fig.8).
 Fittings(e.g.pipeholders,additionalunitsetc.)onthecompressorarepermissibleonly
followingconsultationwithBock.
 Setuponanevensurfaceorframewithsufcientload-bearingcapacity.Use all4fastening
points.
 Correctsetupofthecompressorandmountingofthebeltdrivearedecisiveforrunningcomfort,
operatingsafetyandtheservicelifeofthecompressor.
WARNING! Move compressors only with hoists that have adequateload-bearing
capacity.
A
A
a
a
A
A
a
a
Fig.9