Manual

18
D
GB
F
I
09705-09.2013-DGbFITr
FK30 / ...
235 N
235 TK
275 N
275 TK
325 N
325 TK
235 K
275 K
325 K
Designation Art.-No. Art.-No. Art.-No. Art.-No.
Set of gaskets 80232 80126
Valve plate kit 80240 80242 80241 80010
Set of shaft seals 80123
Oil collector ring 80127
Oil SP 46, 1 Ltr. 02279
Oil SE 55, 1 Ltr. 02282
Oilchange:In principle, an oil change is not mandatory if the system is correctly manufactured
and operated. However, based on decades of experience we recommend that the following oil
change/service work is carried out:
- First oil change during the rst maintenance of the vehicle.
- Then after every 5,000 operating hours, though no more than 3 years, clean the oil strainer
at the same time. If necessary, also empty the oil reservoir at the shaft seal.
Annualchecks: Oil level, tightness of the compressor, running noise, pressures, temperatures,
function of the auxiliary equipment check.
The valve is maintenance free.
However, constant leakage can occur after blowing off due to abnormal operating conditions. This
leads to reduced performance and increases the compressed gas temperature. In this case check the
valve and replace as necessary.
6.4 Integrated decompression valve(onlyFK30/275+325)
Only use genuine Bock spare parts!
6.3 Recommended spare parts
6.1 Preparation
6.2 Work to be carried out
6| Maintenance
WARNING! Beforestartinganyworkonthecompressor:
Switch off the compressor and secure it to prevent a restart.
Relieve compressor of system pressure.
Preventairfrominltratingthesystem!
  Aftermaintenancehasbeenperformed:
Connect safety switch.
Evacuate compressor.
Release switch lock.