Installation guide
Design Information
4
PRODUCT DIMENSIONS AND CLEARANCES NOTE: Appearance will vary by model.
TOOLS AND PARTS REQUIRED 
(NOT SUPPLIED)
 #2 Phillips screwdriver
 Hand held drill
 High speed drill bit, 3/32" diameter
 3/8" slot head screwdriver
 Level
 Saw
 2x4 or 2x2 lumber for installing runners 
or 3/8" plywood for floor (if required)
 Wood screws or other hardware for installing 
runner or shelf to support oven (if required)
 Safety glasses or goggles
PARTS SUPPLIED 
 6 brass screws (3 required, 3 extra)
 5 color matched screws (4 required, 1 extra)
 Bottom trim
ELECTRICAL TOOLS AND PARTS 
REQUIRED (NOT SUPPLIED)
 Junction box
 Electrical cable (3-conductor or 4-conductor wire as 
required by local codes)
 UL-listed conduit connectors
 Wire cutters and wire strippers
ADVANCE PLANNING
 These ovens may be installed directly into a 30” wide 
oven cabinet.
 Cutout dimensions are NOT the same for installation 
with or without an accessory storage drawer. Make 
sure to use the correct cutout when preparing the 
opening.
 NOTE: Model ZSC2202 CANNOT be installed with 
an accessory storage drawer. See Installation 
Preparation Without an Accessory Storage Drawer  
for this model.
IMPORTANT³ This oven is not approved for 
use above another built-in Advantium Speedcook 
oven, a side by side installation or below a 
countertop.
 
For personal safety, this oven cannot be installed 
in a cabinet arrangement such as an island or 
peninsula.
7KHRYHQPXVWEHLQVWDOOHGDWOHDVWµDERYH
the floor.
$OORZIRUFOHDUDQFHWRDGMDFHQWFRUQHUVZDOOV
drawers, etc.
&DELQHWVLQVWDOOHGDGMDFHQWWRZDOORYHQV
must have an adhesion spec of at least 194ºF 
temperature rating.
The oven must be securely installed in a cabinet 
that is firmly attached to the house structure. 
Weight on the oven door could cause the oven 
to tip and result in injury. Never allow anyone to 
climb, sit, stand or hang on the oven door.
If installing the drawer accessory, the drawer must 
be assembled to the oven prior to installation into 
the cabinet. See the Accessory Storage Drawer 
Assembly Instructions.
21-1/2”
1”
13”
19”
29-3/4”
1-1/10s
1-3/5s










