Advan tium T_" Built-In Speedcook Ovens Installation Instructions SCB2000, ZSC2000, SCB2001 ZSC2001
gefl_re w)u begin -- Read these instructions completely and carefllllv. IMPORTANT - Save these insti_uctions fl_r local inspector's use. IMPORTANT - OBSERVE ALL GOVERNING CODES AND ORDINANCES. Note to Installer - Be StlYe to leave Note to ConS/llIlei" - Keep WARNING: This appliance these instructions these instructions must be properly If vou received a damaged Oven, you should immediately contact w)ur dealer or builder. Proper installation is tile responsibility of tile installer.
Design Information Buill-I_ 15" Product 28-7/16-/ / Dimensions Speedcook Ove_,_ 27/32"_ [--(Recessed Portion) 20-27/32" D -... 21-7/8" _27/32" "', [ 7/8" 15/32"4_11/16" *. 27/32"_ 14-1/8"_ ,_ qL 1-1/16" 15-27/32_.._25/32"_JJ Models ZSC2001,ZSC2000 15" 28-7/16 '_'_( ReCr_iS0Sn_ d__ V _ 20-27/32" D "'". _27/32" 22-3/8" , ::::::::7_zA 7/8" 15-27/32q _ 15/32"41_11/16" 29-25/32''_ ModelsSCB2001,SCB2000 Advance Plannin, g • These ovens may be installed wall or wall oven width.
Cabinetry Built-In Single Speedcook Speedcook Installation Oven GE/Monogram Speedcook Installed Built-In Ovens above Wall a Oven Construct Solid BottomMin.3/8" Plywood by 2x4orlx2 Runners, all FourSides Construct Solid BottomMin.3/8" 2" Min. PerOven Requirement Supported by 2x4orlx2 Runners, all FourSides 36-3/4"Min Required +JJ Order a 30" wide single oven cabinet oi" cut the opening in a wall to dimensions shown. The rough opening in/ist be: • Depth - 19" Min. • _]clth - 98-1/2" Min.
Installation Preparation Buill-I_ E#ctrical Requirements Single Speedcook Product rating Hz, 30 amps. to a supply fl'eq uency or circuit prevailing This circuit and of the The to a separate Wire of the size must National local or product protected breaker.
Installation Buill-I_ Step Relllo_Je Packagng and Parts Route Conduit Through Cutout • Open tile door and remove packing material with ceramic tray. • Locate owners kit in carton. Remove and save. • Locate box with metal trays in carton. Remove and save. • Locate screws. parts package containing (4 required, 1 extra) Speedcook Ove_,_ IMPORTANT: To protect tile bottom trim, not remo_e tile stvrotoam shipping base tile oxen is slipped into tile opening.
Installation Built-In Speedcooh Ovens St Electrical Shock • Electrical ground • Do not Connect making Failure shock. terminal to do or wire so could to thejm_ction until box betore connection. must be grom_ded to a metallic, system, or a grom_ding be connected to tile on appliance. in fire, tile personal injury or electrical 4-Conductor Branch Cimuit 3-ConductorBranchCircuit BranchCircuit 120VAC appliance. wiring should lead result the supply grounded.
Pub. No, 49-40293 SPECIFICATIONSSUBJECTTO CHANBE WITHOUT NOTICE DWB. NO.16403370P234 (N.B.
