Advantmm • TM Built-In Speedcook Ovens Installation Instructions SCB2000, ZSC2000, SCB2001 ZSC2001
Before you begin -- Read IMPORTANT - Save these IMPORTANT - OBSERVE Note to Installer - Be sure these instructions completely and carefully. instructions for local inspector's use. ALL GOVERNING CODES AND ORDINANCES. to leave these instructions with the Consumer: Note m Consumer - Keep WARNING: This appliance these instructions must be properly with your grounded. 5 Proper installation is the responsibility of the installer.
Design Information Built-In Product Speedcook Ovens 27/32"4],_ 14-I/8"_ Dimensions 4_ :--9/16" 20-27/32" D -,, 21-7/8" 122222::_ ___ 15_-27/32 " Advance Planning 29-25/32"/r • These ovens may be installed directly into a wall or wall oven cabinetry, 30" minimum width. • The fi'ont surface of the oven will be nearly flush with surrounding cabinetry doors. • This oven can be installed over any GE/ Monogram single electric buih-in oven or a single GE/Monogram electric buih-in warming drawer.
Cabinetry Built-In Prepm the Opening Single Speedcook Speedcook Ovens Speedcook Oven Installed above a GE/Monogram Built-In Wall Oven Installation ConstructSolid BottomMin.3/8" Plywood ,Supported by 2x4orlx2 Runners, all FourSides - 28-1/2"_ ConstructSolid 130tt0mMie.3/8" _" Plyw0ed Supportedby 2x40rlx2 Runners,all FourSides 3B3j4M,0 Required Order a 30" wide single oven cabinet or cut the opening in a wall to dimensions shown. The rough opening must • Depth - 19" Min. • Width - 28-1/2" Min.
Installation Preparation Built-In Elect,Jcal Requirements Speedcook Ovens Single Speedcook Installation Product rating is 120/208 or 120/240 volt, 60 Hz, 30 amps. This product must be connected to a supply circuit of the proper voltage and frequency and protected by a time delay fuse or circuit breaker. The power supply should be brought to a separate 30 ampere branch circuit.
Installation Built-In • Open the door and remove packing material with ceramic tray. • Locate owners kit in carton. Remove and save. Remove Packaging and Parts Route Conduit Through Cutout Speedcook Ovens IMPORTANT:To protect the bottom trim, do not remove the styrofoam shipping base until the oven is slipped into the opening. • Locate box with metal trays in carton. Remove and save. • Locate parts package containing screw's.
Installation Built-In Electrical Shock Speedcook Ovens Hazard • Electrical ground is required on the appliance. • Do not connect the electrical supply until appliance is permanently grounded. • Disconnect power to the junction box before making the electrical connection. • This appliance must be grounded to a metallic, permanent wiring system, or a grounding connector should be connected to the Connect Elect Jcal grounding terminal or wire lead on the appliance.
Pub, Ne,49-40103 SPECIFICATIONSSUBJECT TO CHANGE WITHOUT NOTICE DWG. NO. 164D3370P101 (N.D.
