Installation guide

Installation
Warming" Drawer
P vide
Cabinet
Support
23-1/2"
2"x 4"or
EquivalentRunners
] / / _\
' J \=
=
= ,
=
=
=
=
=
=
=
=
=
=
=
=
=
=
=
=
,I
i
27"
IMPORTANT: When installed below a single or doubleoven,
checkto be sure that any ovensupports abovethe cutout do not
obstruct the 23-1/2" required depth of the warming drawer cutout.
• A 2" rain. clearance between ()veil and
wanning drawer cutouts are required.
Additional clearance may be required if
2 x 4 blocks are used to sui)port runners or
solid floor of the ()veil above.
• The warmer drawer may be supl)orted by
either a solid bottom, 2 x 4 or 2 x 2 runners.
23-1/F
I,
i
/.(j_ 2"x 4" or
Equivalent Runners
// _\ ,
/ \ :i
1
i
1
1
1
1
1
1
_2F_
30"
• The suI)I)ort must be level and rigidly
mounted, flush with the bottom edge of
the cutout.
- There is no way to level the drawer once
it has been installed. Be sure sui)ports are
level.
• The entire weight of the drawer is SUl)l)orted
by the itlnners or solid floor and mtlSt be
capable of supi)orting 150 lbs.
stq) z
Install
Anti-Tip
Brachets
WARNING:
ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to prevent
the drawer from tipping forward when
opened and loaded. Failure to do so could
result in personal injury.
PRI CAUTIONS :
CONTRE LE BASCULEMENT
Pour 6viter les blessures, il faut installer role
patte de retenue pour emp6cher le tiroir de
basculer quand il est ouvert et plein.
., 2x4 or 2x2 ...
/" Runners or Solid ".-
Bottom
Install
2x4or2x2
Anti-TipBlock
Against Rear
CabinetWail
9" FrornFloor
to Bottorn
of Block
St@ 2
Install
Warming
Drawer
• Slide left corner of tile drawer into tile
opening.
• Push power cord into the hole leading to
the outlet location. Thread the cord through
as drawer is being i)ushed back into the
opening. Check to be sure power cord does
not get trapped tulcler tile drawer.
- If the outlet is installed inside the
opening, i)lug tile cord into tile outlet.
In this location, the excess power cord
length should be coiled and taped to
the right side of the unit.
• Push the drawer back tmtil the fl'ont flange
is flush to tile cabinet fl'ont.
• Open tile drawer flfllv.
• Drill pilot holes through tile holes in tile
overlaping fl'allle_ one on each Coi'nei',
• Drive wood screws provided into each coi'nei',
7