Installation guide

Design Information
War m i *_g"l) rawer
Installation
Below
Wall Ovens
NOTE:Additional clearance between
cutouts may be required. Checkto be
sure that ovensupports above the
Warming Drawer location does not
obstructthe required interior 23-1/2"
depth and 9-1/4" height.
2x2or 2x4
Anti-]ip Block
Against Rear
Wall, 9" From
Floorto
Bottomof
Block
2" Min.
Overlapon
All Sides
2x2or2x4
Anti-TipBlock
Against
Wall, 9" From
Floorto
Bottomof
Block
1" Min.AboveToekickorAdjust
to OvenInstallationHeight
_-1/2' Min.
Inside_-
Oven
Cutout
Allow 5/8"
Overlap on
All Sides
/
NOTE:Additional clearance between
cutouts maybe required. Checkto be
sure that oven supportsabove the
Warming Drawer locationdoes not
obstruct the required interior 23-1/2"
depth and 9-1/4" height.
10-1/2"
1" Min.AboveToekick
When installed under a wall oven:
X,_arming ch'awers are approvecl for installation
below only certain specifiecl wall oven models.
See the label attached to the top of the
warming ch'awer for apl)roved models.
• When installe(1, the front lace of the drawer
will be nearly flush with a(!iacent cabinetry
cloors.
• Drawer overlaps will conceal cut edges on
all sides of the opening,
The rough opening fin" the drawer must be:
- Depth: 23-1/2" rain. fl'om insicle back to
fl'ont of cabinet fl'ame.
- Width: 25-1/9" fin" 27" wide models,
28-]/2" for 30" wide m oclels.
- Height: 9-1/4".
- Allow 2" rain. between oven ant1 drawer
cutouts for clearance of overlal)s.
NOTE: If you are installing in frameless cabinets, it may
be necessary to install 1/2" wide cleats to accept
drawer mounting screws. See drawer for mounting
screw locations.