GE Monogram® Installation Instructions Stainless Steel Professional Outdoor Cooking Centers 48" Natural gas models: ZGG48N42 ZGG48N31 48" Liquid Propane models: ZGG48L42 ZGG48L31 36" Natural gas models: ZGG36N31 ZGG36N21 36" Liquid Propane models: ZGG36L31 ZGG36L21 27" Natural gas models: ZGG27N21 ZGG27N20 27" Liquid Propane models: ZGG27L21 ZGG27L20
Before you begin—Read these instructions completely and carefully. IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Use and Care Book for future reference. If you received a damaged cooking center, you should contact your dealer. Installation of this cooking center requires basic mechanical skills.
Design Information Outdoor Cooking Centers Models Available Accessories Monogram Outdoor Cooking Centers are factory set for LP or natural gas. Order the model for your installation situation.
Design Information Outdoor Cooking Centers 12" Min. to Combustibles 3" Clearance for Lid Product Dimensions & Clearances 13-7/8" 16-1/4" 10-1/2" 22-3/4" 24-3/4" 27" 2" 27" Wide Models 12" Min to Combustibles 3" Clearance for Lid 12-1/2" 9-1/2" 35-7/8" 22-5/8" 25-3/8" 2" 36" Wide Models 12" Min.
Design Information Outdoor Cooking Centers Advance Planning • Monogram Outdoor Cooking Centers are designed to be installed on a grill cart or into an enclosure. 27" Models: • In a non-combustible (masonry) enclosure, the grill drops into the opening. A deck or ledge on each side is required for support from the bottom. • Insulated jackets are available to allow the grill to be installed in a combustible enclosure.
Installation Outdoor Cooking Centers 1 Step Remove the Packaging • Open the box and remove packaging. • Open the grill lid and remove white plastic tie-downs on burners. • Remove side burner grate and aeration pan. • Remove tie-downs on burners. • Open the hardware accessory carton and check contents. 36" and 48" models have side shipping brackets. Remove side brackets when installing into an enclosure. Shipping brackets may remain in place when installing into a cart.
Installation Outdoor Cooking Centers 2 Step Provide Support Built-In Installation All Outdoor Cooking Centers can be installed on a cart designed specifically for that model size. Follow the installation instructions provided with the carts to install. Proceed to Gas supply to complete the installation. CAUTION: The grill is heavy. 2 people are required to lift and place the grill into the cart or the enclosure. • All models may be installed into a combustible or non-combustible enclosure.
Installation Outdoor Cooking Centers 36" Models 12" Min. to Combustibles 3" Clearance for Lid 34-1/2" Install Electrical Outlet for Rotisserie On Right side (6.5 AMP Min.) 22-3/4" 12" Min. to Combustibles 3" Clearance for Lid 40-1/2" 35-1/2" 18-1/2" 4x4 Opening for Gas Supply Line Opening for Access Doors 3-1/8" 10-1/8" 36" wide models: Installation in a non-combustible enclosure. 48" Models 12" Min. to Combustibles 3" Clearance for Lid Install Electrical Outlet for Rotisserie On Right Side (6.
Installation Outdoor Cooking Centers 3 Step Provide Gas & Electrical Supply WARNING PRODUCT STORAGE When storing LP models indoors, disconnect the LP tank. Store the tank outdoors in a well ventilated area. Do not store spare LP tanks in or near the Outdoor Cooking Center enclosure. Threading Compound Must Be Resistant to L.P. Gas LP GAS MODELS • Connect the regulator/Quick Connect assembly to the hose attached to the grill.
Installation Outdoor Cooking Centers ELECTRICAL SUPPLY Models with rotisserie require 120V, 60Hz. and connected to an individual properly grounded branch circuit protected by a 15 amp circuit breaker or time delay fuse. The power cord on the rotisserie is equipped with a three-prong (grounding) plug which mates with a standard three-prong grounding wall receptacle to minimize the possibility of shock hazard from this appliance.
Installation Outdoor Cooking Centers 5 Step Check Burners, Drip Trays and Grates • During shipping parts, such as burners and reflectors may have moved. Check to be sure all parts are in position. • Remove the smoker tray (if so equipped). Check to be sure smoker burner and deflector plate are installed properly. The burner and plate should be placed over the holding pin at the back and front of the grill.
Installation Outdoor Cooking Centers Step 6 Lighting the Grill WARNING Do not attempt to light the grill if the odor of gas is present. CAUTION: Keep hands and face as far away from the grill as possible when lighting. • Open the lid and remove the side cooktop burner cover. • Turn all knobs to “OFF” position. • Turn gas supply on at the LP tank or shut-off valve. NOTE: When lighting the burner for the first time or after a LP tank change, allow up to 20 seconds to purge air from the lines.
Installation Outdoor Cooking Centers 7 Step Adjusting the Burners Adjustments should not be required, unless vibration during transit or variations in local gas supply make minor adjustments necessary. 1-1/2" Adjustments must be made by a qualified technician at the time of installation. Extreme care should be used if adjustments are made after installation. 3/8" • Turn gas supply on. • Push and turn the burner control knobs to the “LITE” position.
Installation Outdoor Cooking Centers Install Rotisserie (If so equipped) 14 27" Wide Models: • Slide the motor down into the channel on the left side and tighten thumb screw. • To use, place pointed end of the skewer into the motor, and the threaded end resting on the right side support. • Remove the handle from the threaded end of the skewer before using. 36" and 48" Wide Models: • The motor will rest on the cast iron block and can be tightened against the grill by turning the black knob.
Install Access Doors Outdoor Cooking Centers ZXADYSS Double Access Doors 24-1/8" Double Access Doors 26" 18-1/4" Double Access Doors 20-1/8" • The opening for double access doors should be 24-1/8" wide and 18-1/4" high. Installation • Place the frame into the opening and secure with appropriate screws on all sides as shown. • Hang the doors on the hinges as shown.
Note: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram® local service in your area, call 1-800-444-1845. Note: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. Monogram. ® We bring good things to life. Pub. No. 49-80009-3 Dwg. No. 164D3333P227 (N.D. 728) 3/03 10743-Rev.
