GE Monogram Installation Instructions 30" Electric Radiant Model ZEU30R Monograin.
gefi)rewmbegin--Read theseinstHictions completely andcarefllllv. IMPORTANT--Sax e theseinstructions for localinspector's use, IMPORTANT--OBSERVE ALL GOVERNING CODES ANDORDINANCES, Noteto InstaJler--ge suretoleavetheseinstructions withthe(hmsumer. Note to Consumer--Kee Note--This appliance ATTENTION I) these must INSTALLER: be inst_ uctions properly ALL AN APPROVED JUNCTION THESE PRODUCTS.
Design Information Electronic Contents Desigql Models Radiant Cooktop Information A_ ailable ..................................................................................................................................................................... 3 Adwm_ e Plamling ................................................................................................................................................................... Tools & Materials Required ...................................
Preparing tile Opening Electronic Tools & Materials Required Materials ,]m_ction Needed Box Tools _ire Nuts Radiant Cooktop You Will Need Phillips Head Screwdrher 1/8" Drill Bit & Electric or Hand Drill Ruler t)r Straightedge \ Pencil Saber Saw 13" MAX. Depth Minimum Clearances The following MINIMUM clearance dimensions i///ist be maintained. overhead cabinets of unprotected 1 1/2" MIN. clearance from / cutout to side _wail on the right of the unit _ 30" MIN.
Installation Electronic Vertical Clearance Fixe inches tile cooktop Radiant Cooktop (5") mininmn_ xertical clearance between bottom and am combustible surfitces. 5"Min. Verlical 19 518" width of cut Cutout Diinensions of the To insure accuracy, it is best to make a template when cutting the opening in the cotmter. Make sm'e there is clearance Countertop CO/Ul Wall Coverings, Countertop & Cabinets Clearance inside the cabinet cutting the [ei'tol). Make 2" MIn.
Installation Electronic Attach Foam Strips Radiant Cooktop Bottom of Cooktop Apply the foam strips around the outer edge of the glass. Do not overlap the foam strips, @ I,ocate Remoxe screws Mounting Parts Attach Brackets to k Coo top Screw the the fl'om the hold brackets the literature Hold cooktop down Down trait. I Bracket Repeat MOUNTING SCREW and )ackaoe & Foam Strips " to the side fi_r opposite of side of cooktop.
Electrical Connections Electronic 1 Step X_q/en makin,*_ tile wire connections, shortened. X4qth the Step 2 Step 3 cooktop in place, Insert tile wires from of thejtmction box. open tile conduit use tile entire the front through of the length, Radiant Cooktop of conduit cabinet proxided. The conduit Step 4 tile red and black leads from cooktop conduit to tile corresi)onding, in thejm_ction box. not be door. tile oi)enim, Ground..
Checking tile Installation Electronic Pre-Test Checklist Operation Checklist • Relnove all protective • Check • Checklevel • Check • Remove • Turn on the power operate properly. • Check that the circuit • Check that conduit • See Owner's • NOTE to be sure fihn if l)i'esellt, that all wiring & Cooktop Radiant Operation Cooktop and anv stickers. is secure and not pinched or in contact with moving parts. of appliance.
