Installation guide

mnstaJiation mnsttuctions
| iNSTALL THE ANTbTJP BRACKET
[_ l_)raw a lim_e o]_ the cutout Iqoor at the ce]_ter of
the cutouL amid exteN_d the lim_e _" dow]_ the g_ce
of the cabim_et.
_Fo]d or c_t the f_xmt edge of the template, a]<mg
the {_xmt g_fide ]h_e_ Place the template fi_s]]
a]oi_g the f_xmt edge of the cl_tol_t floo_; a]]gn]m_g
the ce]lter ]im_e of the template _it]l the ce]lter ]im_e
of the clltoIlt floor. Mark the ce]/ters of the t_ko
scre_ holes _it]] am_ a_] or ce]_ter preach f_r the
am_ti-ti I) bracket ]ocatio]_ as show]_.
//
Cutout Floor
_ Remove the template amid drill two holes for the
a m_ti-ti p bracket.
Screws
' I
Anti-Tip
>-<.
Bracket
_ l_sta]l the a_ti-tip bracket o_to the cutout floor
Iosi_ r t'wo bi"o_ze i'olH_d-]_ead sc]'ews.
1-_ INSTALL MICROWAVE OVEN
INTO CABINET
_ Slide the microwave oxen part way into the cabinet
oi)ening.
[_] Plug in the microwaxe oxen.
BottomDuct sembly
Anti-Tip
Bracket
[]
[]
[]
Bottom Bracket
The bottom bracket must be fiat to the cutout
floor to engage correctly with the anti-tip bracket
as shown. Careflfllv slide the microwave oven back,
engaging the anti-tip bracket. Make sm'e the
power cord is not mashed or cut as VOlt slide the
microwave into place.
Center the microwaxe oxen within the
ct/to/It ol)enin_,.
Ensure the microwaxe oxen is accurately centered.
I,ine up the center line on the cabinet with the
triangular hole on the front of the bottom duct.
Opening
Screws _"
Triangular Positioning
centerh01e Flange
[_] Drill pilot holes through the positioning flange
and then install four bronze round-head screws
at the front of the bottom duct as shown.
3