Installation guide

Installation Instructions
ISTEP 31 LEVEL
• Use an a(!justable wrench to turn the leveling legs
and raise or lower the product.
• A@lst careflllly; the product should be level and
phunb with cabinetr> and should align with a@_cent
toekick height,
Turn Right to Lower
Turn Left to Raise
If you skipped Step 2:
• Select the hinge cover marked "R" or "i,", depending
on door swing.
• Peel backing off the tape inside the decorative
hinge cover. Press and snap into position.
• Snap the screw hole cover into place on the
opposite side.
ISTEP 51 SLIDE PRODUCT INTO
THE CUTOUT
• Carefully, slide the unit into the opening.
Be careful not to entangle power cord.
• Make certain that the door prot_ udes 1" bevond
the surrounding cabinets.
• Check again to be sure the unit is level,
ISTEP 61 INSTALL NAMEPLATE
• Follow inst_ uctions on the back page for installation
of the Monogram nameplate.
ISTEP 71 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to
the Owner's Manual for more information.
Allow 24 hours for temperature to stabilize.
ISTEP 41 CONNECT POWER
• Connect power cord plug to a i)roperlv grounded
receptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
6