Installation guide

Installation Instructions
ISTEP 21 REVERSE DOOR SWING
SKIP THIS STEP IF DOOR SWING SUITS THE
INSTALLATION
Parts Included:
• Top left case hinge
• Bottom lefi case hinge
• I,eft and right side decorative hinge cover
• Decorative hinge screw hole cover
• Torx ® driver bit
Tools Required:
• Phillips screwdriver
• Electric drill
Remove the door:
• Flatten tile shipi)ing carton to use as a pad.
• Remove the 2 screws and the toekick. Set aside the
screws and toekick for final installation,
• Use the supplied Torx ® bit aim electric drill to
remove tile 3 screws holding tile top case hinge.
I,ift off the hinge. (Screws will be used to install the
new hinge.)
• i,ifl tile door off tile bottom case hinge.
• Remove tile bottom case hinge pin and bracket.
Rotate the door:
Tile handle will be on tile right side of tile door;
hinges will be installed on the leit side of the case,
• Remove tile door stop and cam riser on tile original
bottom right side of the door.
• Remove tile fill plug on tile top right side
of the door,
• Turn the door over and reinstall the fill plug on the
new lett side,
Reinstall the door:
• Install tile original door stop and cain riser onto
tile bottoln left side of tile door.
• Install tile new supplied bottom case hinge pin and
bracket onto bottom left side.
• Place the door onto the bottom case hinge.
• Install tile supplied lett-hand top case hinge with
the 3 original screws.
• Select the hinge cover marked with an "i,".
• Peel backing off the tape inside the decorative
hinge cox er.
' Install Covers
• Press and snap tile hinge d3/
coxer into place. /:°
V
" Snal) the screw h°le c°xerint° _11
place on the oi)posite side
IMPORTANT:
Check to be sure screws are tight and that tile door
is straight and does not sag. Tile door should swing
freely.
Install
3 Hinge _i
Screws i
Remove
TopHinge
Remove
Hinge
Hinge
Pin and
Bracket
Apply Monogram Nameplate:
• Install tile Monogram nameplate See instiuctions
and telni)late on back cover.
Install Toekick
Tile toekick has a
cutout on tile
lett and right
sides,
Remove
the plug
on the lett
side and
reinstall on
the right
side. If wm
choose to install
the stainless steel toekick
reinstall the plug on the right side of that toekick
• Install original screws and spacers or screws and
spacei_ supplied with the stainless steel toekick
Install screws through the spacer standoff toekick
and into the base as shown
5