Installation guide

Design Guide
THE INSTALLATION SPACE
34-1/2"-35"
23-3/4"
Handle and
handle standoff
depth is 1-3/4"
1_23-3/4"_
The cutout depth should be 24"
The cutout dimensions shown allow for a full door
swing and access to the pull-out racks when installed
as a built-in in standard 24" deep cabinets.
• The wine chiller, wine reserve and beverage center
can be installed freestanding.
• If installing between frameless cabinets, a 1/9" wide
filler strip or side panel may be needed on hinge
side. The filler strip will act as a spacer between the
case and a(!iacent cabinet door swing. The width
of the opening must include the filler panels.
NOTE: The door should protIude 1" bevond the
surrounding cabinets.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended, Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall as shown, Electrical must
be located on rear wall as shown, NOTE: OF]
(ground tault interrupter) is not recommended,
PRODUCT CLEARANCES
The wine chiller, wine reserve and be_era-e center is
lhctor_ set for a l l 0 ° door swing.
When installed in a corner:
• Allow 4" rain. clearance on the hinge side fl)r the
90 ° door swing and to allow racks to slide out.
• Allow 10" minimum clearance on the hinge side
fi)r a filll 110 ° door swing.
10" Minimum
to Wall
i
, L
110° .. \
.......... --,"',A)
90° Door Swing
i-- i
I
I
I
i
\ =
',,, i
I
90 ° i
R
...... - 4--J,
t
21-5/8"
23-5/8"
4" Minimum
to Wall
• The door swing is rexersible on all models. If
desired, change the door swing before installation.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstiucted fin.
air circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 90°F (32°C).
• Do not install where it will be subject to direct
sunlight, heat or moisture.
• These products are not designed to be stacked one
over the other.
Black or Stainless Steel Toekick Options
• These products are shii)ped with a black toekick
installed, An optional stainless steel toekick is also
supplied with each product. For shiI)ping purI)oses,
the stainless steel toekick is secured to the back
of the unit.
SIDE-BY-SIDE INSTALLATIONS
Increase st(>rage capacity by installing tw(> Mon(>gram
beverage centers, wine chillers or wine reserves together.
Or, fin" a complete refreshment center, install any two
of these units together.
• A side-by-side installation requires at least a 47-1/2"
wide opening. No trim kits required.
• Products Illtlst operate fl'om separate, properly
grounded receptacles.
r
34-1/2"-35"
Outlet
li0-1/2'+_14 10-1/_"
t t
is-, ,
/-I/L
47-1/2" Min.
3