Manual
(;are and (;leaning
I_emaker
Light bulb
* Dlacement
Tile icemaker has a light bulb ill tile top of tile
storage bill. To replace it, open the bin door
and fl)llow these instructions:
1. Unplug tile icemaker or disconnect power.
2. Remove the 3 screws that hold the cutter
grid cover ill place. Reach behind tile
control panel and pull tile light bulb down.
3. Replace with a 12-w_lt wedge base-type bulb
(automotive #917). I,ocate the light bulb
receptacle at tile top behind tile control
panel. Mign the flat edge of tile light bulb
with tile receptacle and snap the bulb
into place.
4. Replace the cutter grid cover with the
3 screws.
5. Plug in tile icemaker or reconnect power.
D cation
and moving
To shut down the icemaJcer:
1. Unplug tile icelnaker or disconnect power.
2. Ren/ove all ice fl'oln the storage bin.
3. Sh tit ot1 tile water supply.
4. Relnove the 2 screws in the lower access
panel aim tile 2 screws fl'oln tile base grille
area of tile fl'ont panel support. Pull torward
to rei/love tile lower access panel,
U L
5. Disconnect tile ildet and outlet lines to
water wdve. Allow these lines to drain and
then recolmect to the wdve.
6. Replace tile lower access panel aim screws.
Drain water fl'oln water reservoir bv
relnovii_g the drain cap. Also, remove water
froln drain line. I,eave tile door open
to allow the icelnaker and water reservoir
to dry out completely:
7. Betore using again, clean the icelnaker
aim storage bin.
IMPORTANT: Every time the icemaJ_er is
turned off, you MUST clean the icemaJ_er
system with the Nickel Safe Ice Machine
Clemmr. See Care and Cleaning--Ieemaher
system section for instructions.
8. Plug in the icemaker or reconnect power.
NOTE: All components of tile icemaker are
perlnai_ently lubricated at tile factory. They
should not require any additional oiling
throughout tile nolmal lite of tile umchine.
J_e_TerSe
Osmosis
system
IMPORTANT: Tile perfimnance of tile
icelnaker inav be affected when colmected to
a Revei_e Oslnosis svsteln. An RO systeln inav
also reduce water pressure aim altect tile fill
cycle, which is dependent on tilne aim flow.
The reduced water pressure (less than 90 psi)
Inav cause tile reservoir not to fill and flush
properly durii_g tile ice umking cycle.
Do not use copper tubing when the icemaker is
cmmected to a Reverse Osmosis water system,
13