Daintree® Networked Wireless Wall Dimmer (WWD2) Surface Mounting, 4 Buttons Installation Guide Installation 1 4 Use a standard screwdriver to open the faceplate, Pull the plastic insulation strip out of the battery compartment. If you want to install the device on the wall, use the 3M tape in the package to stick the device firmly on the wall.
Daintree® Networked Wireless Wall Dimmer (WWD2) Surface Mounting, 4 Buttons Installation Guide Personality Change 1 Hold the reset button and 2nd button for 5sec to change the personality to dual zone mode. 2 Hold the reset button and 4st button for 5sec to change the personality to scene mode. 2 Take off the single button and replace another one you want. Button Change 1 Take off the button module from the devices. 2 3 Psl contact your agent if you want to customize the button.
Daintree® Networked Wireless Wall Dimmer (WWD2) Surface Mounting, 4 Buttons Installation Guide Battery Replacement 1 4 The device’s LED flashing every 30 seconds indicates that the batteries need to be replaced. Use a standard screwdriver to open the faceplate. 2 3 Separate the battery cover from the device. Replace the batteries with AAA batteries. All batteries need to be replaced at the same time. Install the faceplate onto the device. Product Dimensions 15.30 15.00 32.80 70.00 66.50 114.
Daintree® Networked Wireless Wall Dimmer (WWD2) Surface Mounting, 4 Buttons Installation Guide Product Overview Technical Data Product Specifications Dimensions 114mm H x 70mm W x 15mm D Weight 130g Power Supply (4) AAA1.
Daintree® Networked Wireless Wall Dimmer (WWD2) Surface Mounting, 4 Buttons Installation Guide Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
