Brochure
Without Compromising the Integrity of Inspection
Accurate
With encoders on all axes, repeat positioning of scan
parameters is guaranteed. The AutoTrak Plus, two-
dimensional bi-directional contour following system,
ensures that the probe travel path covers 100 % of the
surface. The wheel may be tested ange up, ange
down, fully assembled ange to ange, and can handle
complex proles (e.g., racing car wheels).
Minimizing User Errors
WheelScan 5 provides a variety of methods for entering
and retrieving data. The aim of the unit is to allow the
experienced user total exibility when setting up pre-
cision inspections. The ability to “walk” the equipment
through the tests and take settings from the on-board
encoders ensures that measurements are absolutely
precise for each type of wheel. Once the data has been
set up, it can be stored digitally for easy recall in the
future. The recall can even be automated so that the
total test can be recalled with the single scan of a bar
code, and input errors such as the operator ID and
Job References can also be input by bar code. This
removes the need for manual data re-keying, the
most frequent cause of data error in comparable
systems. For added data protection, a key switch
with user/supervisor mode locks out unauthorized
changes.
WhIRS - Wheel Inspection Reporting System
WheelScan 5 has dierent levels of reporting to
meet all your inspection requirements.
• Real Time Charts - the LCD displays real time
charts for easy and convenient test checks.
• Instant Thermal Strip Chart - provides an in-unit
report for each inspection.
• Oine Data Analysis - link a computer to
WheelScan to print a full color report complete
with all inspection parameters. This can be
printed from a laptop situated next to the
unit or from a PC located on another continent.