Technical Specifications

ValVue Digital Communications Software Ver. 2.80

GE Oil & Gas

$$Switch1Value Value at which Switch 1 activates

$$Switch1Action Switch is Normally Closed or Normally Open

$$RawSignal Signal Value in A/D Counts

$$RawPosition Position Value in A/D Counts

$$PositionStopLow Position A/D Counts at the Lower Stop

$$PositionStopHigh Position A/D Counts at the Upper Stop

$$OptionConfig

$$OptionConfigEx0

$$OptionConfigEx1

$$OptionConfigEx2

$$OptionConfigEx3

Data describing the hardware installed on the positioner

$$Friction Friction Measured from a Standard Actuator Signature

$$FLowerSpringRange Lower Spring Range measured from a standard actuator signature

$$FupperSpringRange Upper Spring Range measured from a standard actuator signature

$$LowPressureActual Pressure when the actuator is exhausted

$$HighPressureActual Supply Pressure

$$Speed Speed at which the last diagnostic test was run

$$SpeedSaved Speed at which the saved standard signature was run

$$SpeedBaseline Speed at which the baseline standard signature was run

$$LowerSpringRange

$$LowerSpringRangeSaved

$$LowerSpringRangeBaseline

Lower Spring Range calculated from the current, saved, or baseline stan-

dard signature

$$UpperSpringRange

$$UpperSpringRangeSaved

$$UpperSpringRangeBaseline

Upper Spring Range calculated from the current, saved, or baseline stan-

dard signature

$$Signature Position/Pressure Pairs -gathered during the Standard Signature Test

$$SignatureSaved Position/Pressure Pairs - saved in the Saved Standard Signature

$$SignatureBaseline Position/Pressure Pairs- saved in the Baseline Standard Signature

Table 5 Report Setup Parameters (Continued)

Report Parameter Information Provided in Report