Technical Specifications

71
ValVue Screens
ValVue SVI II AP Work
ValVue Screens
There are seven screens, correlating to the seven tabs available at the top level of ValVue:
 Monitor - Use this screen to adjust current operating parameters of the selected SVI II
AP, perform HART commands and run positioner setup (See “SVI II AP Monitor
Screen” on page 73).
 Trend - Use this screen to view in a graphical format the live operation of the selected
SVI II AP and capture the current data as a bitmap and save it to the computer
clipboard. You can then paste the graphical contents into any program that accepts
a bmp file; e.g. Microsoft Word, Excel, Power Point, etc.
 Configure - Use this screen to view and adjust the current SVI II AP configuration
parameters. To adjust the positioner configuration, ValVue must be in the Setup or
Manual mode.
 Calibrate - Use this screen to view and calibrate the stop positions and the feedback
control parameters (PID tuning parameters).
 Diagnostics - Use this screen to view continuous diagnostics information and
perform diagnostic tests.
 Status - Use this screen to see the operating and internal status of the SVI II AP.
 Check - Use this screen to monitor some of the basic parameters. This screen is used
primarily for troubleshooting.