Technical Specifications

ValVue Digital Communications Software Ver. 2.80
604
GE Oil & Gas
Check Tab
From the Check tab you can set and monitor some of basic parameters. This tab is used
primarily for troubleshooting.
Figure 20 Check Tab
Fields
Position The current position of the valve in percent open. 0% is always closed
and 100% is open. Because the travel of a valve may exceed its nom-
inal travel, positions greater than 100% are possible (see Open Stop
Adjustment).
Raw Position The A/D value measured from the position sensor. This is used for
troubleshooting purposes.
Pressure The actuator pressure which can be reported in psi, bar, or kPa. You
can select the units from the “Configure Tab” on page 571.
Raw Pressure The A/D value from the pressure sensor. This is used for troubleshoot-
ing purposes.
Current The value of the input signal in milliamps.