Technical Specifications

ValVue Digital Communications Software Ver. 2.80
600
GE Oil & Gas
$$LowPV - Low calibration for process variable
$$HighPV - High calibration for process variable
$$LowSP - Low calibration for setpoint
$$HighSP - High calibration for setpoint
$$ContP - Controller P
$$ContI - Controller I
$$ContTD - Controller D
$$ContKD - Controller D gain
$$ContBeta - Controller beta
$$LSPLimit - Lower setpoint limit
$$USPLimit - Upper setpoint limit
$$LowAlarm - Low alarm value
$$HighAlarm - High alarm value
$$ManResetBias - Manual reset bias
$$OutRateLim - Controller output rate limit
$$ContDZ - Controller dead zone
$$DevSource - Derivative source
$$AlarmType - Alarm type absolute/deviation
$$SPTracking - Setpoint tracking on/off
$$FreezeOnBad - Freeze on bad value on/off
Menu - Diagnostics
When you right-click on the Diagnostics tab, a context menu appears (the items depend upon
what diagnostics have been run):
 View Diagnostic Graph – Views the data from the last run diagnostic procedure.
 Save Diagnostic Data – Saves the data from the last run diagnostic into a disk file. The
disk file can be imported into spreadsheets or read with ValVue.
 Diagnostic Report - Opens a dialog to select a .dgn file and specify specific group data
(up to three of the same type) for presentation on a diagnostics report.
 Save Signature in SVI – Saves the last run signature in the SVI.
 Save Signature as Baseline – Saves the last run signature as the baseline signature in
the SVI. You must have administrator level privilege to select this option.
 Report Setup – Allows the user to select a report file and a report printing program
 Report – Generates a report of the SVI parameters.