Technical Specifications

561
Monitor Tab
You can also change the manual setpoint by right-clicking in the
indicator. A dialog box appears where you enter the exact setpoint
for use.
Pressure The actuator pressure, which can be reported in psi, bar, or kPa.
You can select the units from the “Configure Tab” on page 571.
Send Command Sends the selected Hart command to the SVI, reads the results,
and displays them in the result box to the left.
Setup Wizard From the Setup Wizard you can rapidly setup the SVI by configur-
ing some basic parameters. By selecting the appropriate check
boxes the you can set the device identification, select the air
action, perform a travel calibration, and an autotune. Used primar-
ily for rapid setup of standard application valving the Setup Wizard
dramatically reduces commissioning time in the field.
The task list shows what processes will run. When started from the
Setup Wizard, several tasks can be listed and are performed in
order For processes started from the “Configure Tab” on page 571
or “Diagnostics Tab” on page 589, only one task is listed and
started.
Figure 2 Setup Wizard