Technical Specifications

209
Creating Report Template Files
Monitor
$$ActuatorType Single/Double Acting Actuator
$$PosErrorBand Position Error Band
$$PosErrorTime Position Deviation Time
$$Charact Characterization (Linear, Equal Percentage, etc.)
$$CustomCharact Displays the Custom Characterization constants
Individual items of the characterization curve may be selected by enter-
ing:
$$CustomCharact[n] where n is a number between 0 and 17
$$ButtonLock Button Lock Level
$$Bumpless Bumpless Transfer On/Off
$$BumplessSpeed Time to move from Manual to Normal (operating) mode
$$TightShutoff Tight Shutoff On/Off
$$TSValue Tight Shutoff Value
$$ULimitStop Upper Position Limit On/Off
$$ULSValue Upper Position Limit
$$LLimitStop Lower Position Limit On/Off
$$LLSValue Lower Position Limit
$$NearClosed Value below which is considered Near Closed
$$PosUnits Position Units of Measure (always %)
$$PresUnits Pressure Units (psi, bar, or kpa)
$$SignalUnits Signal Units (always mA)
$$Language SVi1000 Display Language
$$LowSignal Low Calibration Value
$$HighSignal High Calibration Value
$$P Proportional Gain In controller
$$Padjust Adjustment to P when valve is exhausting
$$I Integral action of controller
$$Beta Step size adjustment in controller
$$D Derivative action of controller
$$PosComp Position range compensation of controller
$$DeadZone Dead zone of controller
Table 1 Report Setup Parameters (Continued)
Report Parameter Information Provided in Report