Technical Specifications

© 2014 General Electric Company. All rights reserved.
300 | =GE Oil & Gas
The selected fault is cleared from the Active Faults list and the Clear Individual Fault button
returns to an inactive state (Figure 321).
Figure 321 Individual Fault Cleared
Set Fail High/Low
On the Pneumatics and Electronics tab on the Status screen you can set whether pneumatics,
actuator, or electronics testing fail at a predefined high or low level. To change this setting you
must be in Setup mode ( “Change Mode” on page 83) and click on the correct radio button: Fail
High or Fail Low.
Status Fault Code List
The Status screen displays all faults as bytes in the HART Device Status Command. Table 8 lists
all Bytes and their correlating fault bits in the HART Device Status Command.