Technical Specifications

© 2014 General Electric Company. All rights reserved.
104 | =GE Oil & Gas
The allowed SVI II ESD Parameters are listed in Table 5. Use the report file (report.rtf) shipped
with the application for examples.
Table 5 Report Setup Parameters
Report Parameter Information Provided in Report
$$Tag Tag Name
$$Descriptor Descriptor
$$Date Date
$$Message Message
$$AssemblyNumber Final Assembly Number
$$MfgID Manufacturer’s ID (101 for Masoneilan)
$$DeviceType Device Type (200 for the SVI II ESD)
$$DeviceID Hart DeviceID
$$HWRev Hardware Revision
$$SWRev Software Revision
$$CmdRev Firmware Command Revision
$$PollingAddress PollingAddress
$$Position Position
$$Signal Input Signal
$$Pressure Actuator Pressure
$$IPOutput Signal to the I/P in Counts (0 - 65000)
$$Temperature Circuit Board Temperature
$$LowTemperature Historical Low Temperature
$$HighTemperature Historical High Temperature
$$Output Output from the process controller
$$Mode SVI II ESD Mode
$$SignalPercent Input Signal as Percent
$$AirAction Air-to-Open/Air-to-Close
$$ActuatorType Single Acting Actuator only
$$PosErrorBand Position Error Band
$$PosErrorTime Position Deviation Time
$$Charact Characterization (Linear, Equal Percentage, etc.)