Installation Guide

6
REMOVE TOEKICK
• Remove the 4 toekick screws and
the 2-piece toekick. Set aside for
use in Step 19.
Dishwasher Installation
STEP 2
ADJUST LEVELING LEGS
• Move the dishwasher close to the installation
location and lay it on its back. NOTE: Do not place the
dishwasher on its side.
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base, 1/2”
less than installation height.
CHECK DOOR BALANCE
To check the door balance, hold the top of the dishwasher
firmly.
• Check the door balance by opening and closing the
door.
• If the door drops
when released,
increase the
spring tension.
If the door rises
when released,
decrease the
spring tension.
STEP 3
STEP 1
STEP 4
INSTALL POWER CORD
Skip this step if the dishwasher will be permanently
connected to the house electrical system or has a
factory-installed power cord.
• The power cord and connections must comply with the
National Electrical Code, Section 422 and/or local codes
and ordinances. Maximum power cord length is 6 feet.
Power Cord Kit WX09X70910 or WX09X70911, available
for purchase from an authorized
Haier Appliances dealer, meets these requirements.
• Remove junction box cover.
• Install strain relief in the junction box bracket.
• Insert the power cord through the strain relief and tighten.
• Make sure black, white and green dishwasher wires are
threaded through the hole in the junction box bracket.
• Connect power cord white (or ribbed) to dishwasher
white, black (or smooth) to dishwasher black and
ground to dishwasher green wire. Use UL-listed wire
nuts of appropriate size.
• Replace junction box cover using the screw. Be sure
wires are not pinched under the cover.
Decrease
Increase
Opening the door will cause the
dishwasher to tip forward when it is
not fully installed. When opening the
door prior to the dishwasher being
fully installed, hold the top of the
dishwasher securely with one hand and hold the door
with the other hand. Gloves should be worn.
CAUTION
Adjust to
Installation
Height
Leveling leg
shown with the
dishwasher laying
on its back
Black White
Ground/
Green
Dishwasher
Ground Wire
and Screw
Dishwasher Ground
Wire and Screw
Dishwasher
Wires
Junction Box Bracket
UL Listed Wire Nuts
Strain
Relief on
Power
Cord
Junction Box
Cover