Refrigerator User Manual

[11
l
/
2. Put the drawerslidesback on
the frame. ‘I’heslopedendsmust
beat the front.
3. Reachin, pushthe front ofthe
glasscoverup and, at the same
time, pull it forwarduntil it clears
the frame at the back.
4. Tilt and removethe glass cover.
3. Slide the center and right drawer
slidestowardthe middle and slide
the l/3-width drawer all the way
intothem.
5. Removethe 3 drawer slides.
6. Removethe drawer frame as
foJlows:
~ Lift the front of the frame to free
it from the supportsat each side.
~ Lift the rear of the frame to free
its hooks from the tracks on the
back wall of the refrigerator.
QTilt the frame and take it out.
‘h replace:
1. Fit the hookson the drawer
frame into the second-from-the-
bottornslots on the tracks at the
rear of the refrigerator and lower
the front of the frame until it locks
into position and rests on the front
supports at each side.
/’-’%
—.
1
~
..-.-”
4. Slide the l/3-width drawer all the
wayto the right.
5. Mount the 2/3-width drawer
onto the center and left slides.
, ~. Replace the glass cover,pushing
lts rear edge firmly intothe rear
frame channel and gently lowering
the front into place.
Toremovethe drawers,lift front up -------,------
slightlyand puHthe drawerstraight
out.
[
Toremovethe cover,supportit
with one hand, tilt itand takeit out. .
.. .-
J
S
A
1
~.
-
If the cover suPPortat front center,
(on models so”~quipped)becomes
separated from the drawer cover,
reinstallthe supportbeforereturning
the coverto the cabinet.
,-
To ‘ffeinst.d - Wwer support,
turn the cover and support upside
down and guide the pins on the
support into the hooks on the cover
as shown. Then push firmly until
the pins lock into place.
pqy)
9
-.
...