Installation Guide

ManualsBrandsGE ManualsRefrigerated DisplayGE RV60 LED System

• Tuck wires underneath Wire Cover before installing it

onto the End Cap.

• Attach Wire Cover to LED Light Mounting Tab by

inserting a M2.9x10 pan head tapping screw

(provided) through the holes in Covers and Mounting

Tabs using an installation torque of 3 lbf-in.

NOTE: Tighten slowly until fully seated, do not over

tighten or strip the threads.

• The outer lens and the plastic housing should be cleaned

periodically with a mild liquid dish detergent.

• Do not use chemical cleaners to clean the lens.

• Keep the outside clean. Wipe with a clean cloth lightly

dampened with mild liquid dish detergent. Dry with a

clean, soft cloth.

Attach Covers to Mounting Tab

LED Refrigerated Display Lights – Cleaning Instructions

CAUTION/ATTENTION

Risk of electrical shock. Plastic cover is needed to protect electrical wires from tampering and accidental contact. / Risque de choc

électrique. Le couvercle en plastique est requis pour assurer une protection adéquate contre l'accès aux ls et les contacts accidentels.

Wire

Cover

Mounting Tab

M2.9x10 pan

head tapping

screw

WARNING/AVERTISSEMENT

Risk of electrical shock. Disconnect power to LED Lights before any cleaning operation.

Risque de choc électrique. Débranchez l'alimentation des éclairages à LED avant toute opération de nettoyage.

• Do not wipe the lens with a soiled dish cloth or wet towel.

These may leave a residue that can damage the nish.

• Do not use scouring pads, powdered cleaners, bleach or

cleaners containing bleach because these products can

scratch and damage the nish.

This product is intended solely for the use of commercial refrigerated, display or

case lighting and is not intended for use in any other application.

GE Lighting Solutions • 1-888-MY-GE-LED (1-888-69-43-533) • www.gelighting.com

GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Immersion is a trademark of GE Lighting. The GE brand and logo are trademarks of the General Electric Company.

Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.