Installation Guide
Install Center LED Lights
2
• Place a Center LED Light against the back face of the
mullion near the two holes drilled at the top.
• Insert a #6-32 x 1/2-inch sheet metal screw into the top
slot of the Mounting Tab on the Center LED Light and
into the rst hole that was drilled in the center mullion.
• Use a screwdriver to thread the screw into the drilled hole.
• Repeat for the second screw, and for the lower end of
the Center LED Light.
• Refer to the manufacturing manual for door frame
to ensure there are no components contained inside
the mullion that could be drilled through. Use a
#6 - 3/4-inch self-drilling screw to attach the Center
LED Light into one or two of the additional mounting
holes located near the center of the LED Light.
• Refer to wiring diagram on page 5. Connect the red and
black output wires from the LED Light to the red and
black wires on the LED Driver using the twist lock splice
wire connectors provided.
3
WARNING/AVERTISSEMENT
Risk of electrical shock. Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of kit
installation. Do not leave any other open holes in an enclosure of wiring or electric components / Risque de choc électrique. Seuls les trous
ouverts indiqués dans les photos et / ou les dessins peuvent être faites ou modiés à la suite du montage du kit. Ne pas laisser autres trous
ouverts dans l'enceinte du câblage électrique ou composants.
LED Driver Leads
Center LED Light
Power Leads
Mounting Tab