Installation Guide

Wire stripper/cutter
Tape measure
Screwdriver
Cordless drill
Hammer
7/64-inch (2.8mm) drill bit
Center punch
1
2
3
1
2
3
4
LED light
LED driver
Wire cover
6-32 x 1/2" screws
2
4
5
6
7
WARNING/AVERTISSEMENT
Risk of re or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for installation of LED retrot kit. Check for
enclosed wiring and components. / Risque de feu ou électrocution. Les pièces et câbles électriques risquent d’être endommagés lors du perçage
des trous pour l’installation du luminaire à DEL. Veuillez vérier si des câbles et composantes se trouvent derrière la paroi avant de percer.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects. / Pour éviter l'endommagement de
câblage ou l'abrasion, ne pas exposer le câblage aux bords de feuilles de métal ou d'autres objets tranchants.
Tools Required Components Required
4
1
2
3
1
3
4
2
5
6 7
• Measure the total width of the mullion, and mark a vertical
line half the total width near the top and bottom of the
mullion.
• Prepare for the upper end of the Center LED Light. Mark a
horizontal line a minimum 2 1/8-inches (54 mm) from the top
of the mullion, and another horizontal line 3/8-inch (10 mm)
below this line.
• Prepare for the lower end of the Center LED Light.
— For 48-inch LED Lights mark a horizontal line
46 1/4" (1175mm) beneath the rst line drawn for
the top Mounting Tab.
— For 60-inch LED Lights mark a horizontal line
58 3/32" (1476mm) beneath the rst line drawn for
the top Mounting Tab.
— For 67-inch LED Lights, mark a horizontal line
65 15/32" (1663mm) beneath the rst line drawn for
the top Mounting Tab.
• Center the center punch directly at the intersection of the
horizontal lines and the vertical line (top and bottom) and
establish a dimple.
• Use power drill and 7/64-inch (2.8 mm) drill bit to drill holes
at the intersection of the vertical and horizontal center line.
1
Total width
of mullion
Half total
width of
mullion
3/8"
(10 mm)
LED Driver
wires - top
For 48-inch LED Lights:
46 1/4" (1175mm)
For 60-inch LED Lights:
58 3/32" (1476mm)
For 67-inch LED Lights:
65 15/32" (1663mm)
Center punch
at intersection
and drill a
7/64-inch (2.8 mm)
hole
Prepare for Installation of
Center LED Lights